4.5.4 · CorePaper 1Paper 2Paper 3Paper 4

Force on a current-carrying conductor

In a minute

A wire carrying a current across a feels a . This is the . Reverse the current or the field and the force reverses; reverse both and it does not. Extended students also find the direction of the force, for wires and for beams of charged particles.

You'll be able to

  • Describe an experiment that shows the force on a current in a magnetic field, and what happens when you reverse the current or the field.
  • Use Fleming's to link the directions of force, field and current.
  • Find the direction of the force on a beam of positive or negative particles moving through a magnetic field.
Before you start3 quick questions on what this builds on
Check yourself
The N pole of one faces the S pole of another across a gap. Which way do the field lines in the gap point?
Check yourself
In a wire, electrons drift from left to right. Which way is the ?
Check yourself
What does a current in a long straight wire produce around the wire?

Revise first: 1.2 Motion, 1.5.1 Effects of forces, 4.1 Simple phenomena of magnetism, 4.2.2 Electric current and 4.5.3 Magnetic effect of a current

The motor effect

A current makes its own . Put the current inside the field of a , and the two fields push on each other. So the wire feels a .

Electric motors use the to turn (4.5.5).

To show it, rest a light metal rod across two metal rails. Join the rails to a low-voltage d.c. supply, so the rod completes the circuit. Place a strong so the rod sits between its poles.

1. Switch on. The rod rolls along the rails, so a force acts on it. With no current, there is no force.

2. Swap the connections to the supply, so the current reverses. Switch on again: the rod rolls the opposite way.

3. Put the connections back. Turn the magnet over so its poles swap, which reverses the field. The rod again rolls the opposite way.

View from above. Two straight metal rails run across the page from left to right, one above the other. A light metal rod rests across them at right angles. The left ends of the rails are joined to a d.c. supply, with its positive terminal connected to the upper rail. The rod and the middle of the rails lie between the poles of a magnet: the N pole is above the rails and the S pole is below them, so the magnetic field points into the page, shown by crosses. Arrows show the current flowing from the positive terminal along the upper rail, down through the rod and back along the lower rail. A thick arrow pointing right from the rod is labelled force, and shows that the rod rolls to the right. magnet: N pole above the rails, S pole below ×××× ×× ×××× metal rail metal rail + − d.c. supply light metal rod current current force: the rod rolls to the right × = magnetic field into the page
The rod on the rails rolls when there is a current in it.

Reverse the current or the field, and the force reverses. Reverse both at once, and the two changes cancel: the force acts the original way.

Reversing flips which way the force acts. It leaves the size the same. A bigger current or a stronger magnet gives a bigger force.

The force is biggest when the wire is at right angles to the . A wire that runs along the field lines feels no force.

With an supply, the current keeps reversing, so the force keeps reversing too. A loose wire in the field then vibrates.

Worked examplePriya has a U-shaped magnet, a low-voltage d.c. supply, a switch, leads and a long strip of aluminium foil. Describe an experiment she could do to show that there is a force on the foil when it carries a current in the magnetic field. Include how she shows the effect of reversing the current, and of reversing the field.

Try it first, then reveal one step at a time.

  1. First make a complete circuit with the foil in the field, and say what she sees when the current flows.
Check yourself
In the rails experiment, the rod rolls towards the supply. Which change makes it roll away from the supply instead?
Worked exampleA stiff copper wire hangs like a swing, and its lowest part passes between the poles of a magnet. When a d.c. supply is switched on, the swing kicks towards the back of the bench. Predict which way it moves, with a reason, when: (a) the supply connections are swapped; (b) instead, the magnet is turned round so its poles swap; (c) both changes are made at once; (d) the d.c. supply is replaced by a low-voltage a.c. supply.

Try it first, then reveal one step at a time.

  1. Each reversal of the current or of the field reverses the force.
Check yourself
A wire between the poles of a magnet is pushed upwards when there is a current in it. The current and the magnetic field are both reversed. Which way is the force on the wire now?

Fleming's left-hand rule Extended only

Extended students must find the direction of the force, not just say when it reverses. The force always acts at 90° to the current and at 90° to the field.

When the current crosses the field at 90°, the gives the direction. Hold the thumb and first two fingers of your left hand at right angles to each other.

First finger: the field, from N to S. Second finger: the current, as , from + to −. Thumb: the force, which is the way the wire is pushed.

A way to remember it: First finger for Field, seCond finger for Current, thuMb for Motion.

Diagrams often show a wire end-on, at right angles to the page. A cross (×) means current into the page; a dot (•) means current out of the page.

An N pole on the left and an S pole on the right, with magnetic field lines running straight across between them from N to S, to the right. A straight wire passes through the gap at right angles to the page, drawn end-on as a small circle with a dot in it, meaning the current flows out of the page. A thick arrow pointing up the page from the wire is labelled force. Notes on the right say: field from N to S, to the right; current out of the page; force on the wire up the page. N S force Field: N to S, to the right Current: out of the page (•) Force on wire: up the page
Field to the right, current out of the page: the left thumb points up the page.
Worked exampleThe N pole of a magnet is at the bottom of the page and the S pole is at the top. A wire between them runs across the page and carries a current to the right. Determine which way the wire is pushed.

Try it first, then reveal one step at a time.

  1. Field: from N to S, so up the page. Current: to the right.
Worked exampleA wire at right angles to the page carries a current into the page. One magnetic pole is above the wire and the other is below it. The force on the wire acts to the left. Deduce which pole is at the top.

Try it first, then reveal one step at a time.

  1. The field must be at right angles to both the current and the force, so it points up or down the page.
Check yourself
A wire runs up and down the page and carries a current up the page. The magnetic field points into the page. Which way is the force on the wire?
Check yourself
A wire lies along the field lines between two magnetic poles. It carries a current from the N pole side towards the S pole side. What force does the field exert on the wire?

Beams of charged particles Extended only

A beam of charged particles is a current, so a magnetic field pushes on it too. Each moving charge has its own magnetic field, which interacts with the magnet's field.

A charge that is not moving has no magnetic field, so a magnet exerts no force on it. A charge moving along the field lines feels no force either.

The left-hand rule still works, once you have the current direction right:

1. Positive particles, such as protons or alpha particles: the current is in the direction they move.

2. Negative particles, such as or beta particles: the current is opposite to the direction they move.

The push is always at 90° to the particles' , so the beam follows a curved path.

A beam of electrons in a vacuum travels from the left to the right, into a region where the magnetic field points out of the page, shown by dots. Before the region the beam is straight. Inside the region the beam curves upwards, towards the top of the page. A dashed straight line continuing to the right shows the path the beam would take with no field. A short arrow at the point where the beam enters the field points up the page and is labelled force on the electrons. path with no field electron beam force on the electrons • = magnetic field out of the page
Electrons moving right are a current to the left. With the field out of the page, the force is up the page.
Worked exampleA beam of protons travels up the page through a magnetic field that points to the right. Determine the direction of the force on the protons.

Try it first, then reveal one step at a time.

  1. Protons are positive, so the current is in the direction they move: up the page.
Worked exampleAlpha and beta particles from a radioactive source both travel to the left, through a magnetic field that points up the page. Determine the direction of the force on each type of particle, and explain why the directions are different.

Try it first, then reveal one step at a time.

  1. Alpha particles are positive, so their current is to the left. Beta particles are electrons, so their current is to the right.

You meet the deflection of alpha, beta and gamma radiation again in 5.2.2.

Check yourself
A beam of electrons travels down the page. The magnetic field points into the page. Which way is the force on the electrons?
Check yourself
A beam of electrons passes through a magnetic field and is not deflected at all. Which explains this?

Common mistakes

  • Reversing both the current and the field and expecting the force to reverse. The two reversals cancel, so the force keeps its original direction.
  • Thinking that reversing the current or the field changes the size of the force. It changes only the direction; a bigger current or a stronger magnet makes it bigger.
  • Drawing or using the field between two poles from S to N. Outside a magnet, field lines run from the N pole to the S pole.
  • Extended: taking the direction electrons or beta particles move as the current. Conventional current flows the opposite way, so the force comes out reversed.
  • Extended: using the right hand. The left-hand rule gives the force on a current; Fleming's right-hand rule is for induced current.

Exam tips

  • "Describe" the experiment in three parts: the apparatus (a conductor between the poles of a magnet, in a complete circuit with a d.c. supply), what you see (it moves when the current flows), and each reversal with its result.
  • When you "state" how to reverse the force, name one change: "reverse the current" or "swap the poles of the magnet". Saying "change the current" or doing both at once earns no mark.
  • Extended: for direction questions, write down the field (N to S) and the conventional current first, then use your left hand. Check that your answer is at right angles to both.

Key takeaways

Learn thisMotor effect: a conductor carrying a current across a magnetic field feels a force. The force is biggest when the current crosses the field lines at 90°, and zero when it runs along them.
Learn thisDemonstration: a metal rod on rails, or a loose wire, between the poles of a magnet and connected to a d.c. supply. It moves when the current is switched on.
Learn thisReversing the current, or reversing the field, reverses the force. Reversing both leaves the force in its original direction. Reversing does not change the size of the force.
Learn thisThe force is at 90° to the current and at 90° to the field. Fleming's left-hand rule, for a current crossing the field at 90°: first finger = field (N to S), second finger = conventional current, thumb = force.
Learn thisA beam of charged particles moving across a magnetic field is deflected. Positive particles: current in their direction of motion. Electrons and beta particles: current opposite to their motion. Charges at rest, or moving along the field lines, feel no magnetic force.

Practise this

25 past-paper questions on Force on a current-carrying conductor in the 0625 Extended bank, each with a mark scheme and a worked explanation.

Practise Force on a current-carrying conductor →