Motion
In a minute
is how far something travels each second, and is speed in a given direction. Graphs of or speed against time show how an object moves: the of a distance–time graph gives the speed, and the area under a speed–time graph gives the distance travelled. Near the Earth, with air resistance ignored, falling objects speed up at about . Extended adds , and .
You'll be able to
- Define speed and velocity, and use and the equation for .
- Sketch, plot and read a , tell from it or from data when an object is at rest, at constant speed, speeding up or slowing down, and find a speed from its gradient.
- Sketch, plot and read a , tell how the object moves, and find the distance travelled from the area under it.
- State the value of the near the Earth's surface.
- Use and the gradient of a speed–time graph to find an , tell constant from changing acceleration, and treat a as a negative acceleration.
- Describe how objects fall with and without air or liquid resistance, including .
Before you start3 quick questions on what this builds on
Speed, velocity and average speed
tells you how fast something moves: how far it goes each second. A cyclist moving at covers 5 metres every second.
is the speed, is the travelled and is the time taken. With in m and in s, is in m/s. Rearrange to or when you need the distance or the time.
Try it first, then reveal one step at a time.
- Convert to metres and seconds: and .
- Write the equation: .
- Substitute: , in m/s.
Speed only says how fast. also says which way.
Speed is a : it has size only. Velocity is a : it has size and direction. Two lifts moving at , one up and one down, have the same speed but different velocities.
On a real journey the speed keeps changing, and there may be stops. is the steady speed that would cover the same total distance in the same total time.
Try it first, then reveal one step at a time.
- Total distance: .
- Total time, including the stop: minutes .
- , in m/s.
- Leaving out the stop gives , which is too high.
Distance–time graphs
A shows how far an object has travelled (up the side) at each time (along the bottom). Its steepness, the , is the speed.
Read the graph one section at a time. A is straight and sloping, so the jogger moves at a constant speed. B is horizontal: the distance doesn't change, so she is at rest. C is straight again but less steep than A, so she moves at a lower constant speed.
For a straight section, read the distance and time at both ends and divide the changes.
Try it first, then reveal one step at a time.
- Section A runs from to .
- , in m/s.
Try it first, then reveal one step at a time.
- Section C runs from to .
- Change in distance: . Change in time: .
- , in m/s. This is less than , as the shallower line shows.
When the speed changes, the line curves. A curve that gets steeper means the object is speeding up (accelerating). A curve that gets less steep means it is slowing down (decelerating). The top row of the figure below shows all four shapes.
You can tell the same from a table of data. Equal distances in equal times mean a constant speed. Growing gaps between readings mean speeding up; shrinking gaps mean slowing down.
Speed–time graphs and distance travelled
A has speed up the side. Here a horizontal line means a constant speed. At rest is a line along the time axis, at zero speed. A line sloping up means speeding up; sloping down means slowing down (bottom row of the figure above).
The tram speeds up steadily for s. It moves at a constant from s to s. Then it slows down steadily and stops at s.
The area under a speed–time graph is the travelled. At constant speed, the area is a rectangle: speed × time. When the speed changes steadily from zero, it is a triangle: . Split any other shape made of straight lines into rectangles and triangles.
Try it first, then reveal one step at a time.
- From to s the area under the line is a triangle.
- Base and height .
- , in m.
Try it first, then reveal one step at a time.
- Split the area into a triangle, a rectangle and a triangle.
- First triangle: , from the example above.
- Rectangle, s to s: .
- Last triangle, s to s: .
- Total: , in m.
Acceleration and deceleration Extended only
means "change in". is the final velocity minus the initial velocity, and is the time taken. With in m/s and in s, is in : metres per second, gained each second.
Try it first, then reveal one step at a time.
- Change in velocity: .
- Write the equation: .
- Substitute: , in .
For motion in a straight line, the of a speed–time graph is the . A straight sloping line means a constant acceleration. A curve means a changing acceleration: where it is steeper, the acceleration is larger.
Take the direction of motion as positive. When an object slows down, the final velocity is less than the initial velocity, so and are negative. A is a negative acceleration: means a deceleration of .
Try it first, then reveal one step at a time.
- The acceleration is the gradient of that section.
- (final minus initial) and .
- , in .
- The minus sign shows the tram is slowing down: a deceleration of .
Falling objects
Drop a ball and it speeds up as it falls. Near the Earth's surface, when air resistance is small enough to ignore, every falling object speeds up at the same rate.
The exam papers print on the front. It stays almost the same over a fall from a roof or a cliff, because that height is tiny compared with the size of the Earth.
Try it first, then reveal one step at a time.
- Say what acceleration each ball has.
- Say whether it depends on mass, then conclude.
- Both balls fall with the acceleration of free fall, about . This acceleration is the same whatever the mass of the object. So their speeds increase at the same rate, and they reach the floor at the same time.
changes the motion. It acts upwards on a falling object, against the motion, and it grows as the object speeds up. The figure compares a fall with and without it.
Without air resistance (A) the acceleration stays at , so the graph is a straight line. With air resistance (B) the acceleration gets smaller as the speed rises, so the graph curves and levels off. The constant speed it reaches is the .
Try it first, then reveal one step at a time.
- Start with the forces at the moment she jumps.
- Say how the air resistance changes as she speeds up, and what that does to her acceleration.
- Finish with the forces and the motion at the end.
- When she jumps, her speed is low, so the air resistance is small and she accelerates at about . As her speed increases, the air resistance increases. The resultant force on her gets smaller, so her acceleration decreases. Eventually the air resistance equals her weight. The resultant force is then zero, so she falls at a constant speed, her terminal velocity.
Liquid resistance works the same way. A steel ball dropped into a tall tube of thick oil soon reaches a low terminal velocity, because the drag in the oil grows quickly with speed.
Common mistakes
- Dividing kilometres by minutes and calling it m/s. Convert to metres and seconds first.
- Averaging the speeds of the stages, or leaving out the stops. Average speed is total distance divided by total time.
- Reading a horizontal line on a speed–time graph as "at rest". It means constant speed; at rest is a line along the time axis.
- Using speed × time for a stage where the speed rises steadily from zero. That area is a triangle, so use .
- Extended: losing the minus sign of a deceleration. is final velocity minus initial velocity.
- Extended: saying no forces act at terminal velocity. The forces balance, so the resultant force is zero.
Exam tips
- "Define" speed and velocity in words: "distance travelled per unit time" and "speed in a given direction". An equation alone needs every symbol explained.
- "Calculate": write the equation, then the numbers in it, then the answer with its unit. Convert km and minutes to m and s first when the answer must be in m/s.
- "Determine" a distance from a speed–time graph: show the shapes you split the area into and the area of each.
- "Describe" the motion from a graph: say whether the speed is increasing, decreasing or constant, and quote values, such as "constant at 12 m/s". "The speed is changing" doesn't say which way.
Key takeaways
Practise this
53 past-paper questions on Motion in the 0625 Extended bank, each with a mark scheme and a worked explanation.