Rate equations and orders of reaction
In a minute
A , such as , shows how the depends on each . Each power is an , found only by experiment. is the : it changes with temperature, and its units depend on the overall order.
You'll be able to
- Write a rate equation, and state the order with respect to each reactant and the overall order.
- Explain why a rate equation can only be found by experiment, and link orders to the .
- Deduce a rate equation from initial-rate data.
- Sketch and interpret concentration–time and rate–concentration graphs for zero, first and second order reactions.
- Calculate the rate constant and its units, and explain how temperature affects it.
Before you start3 quick questions on what this builds on
Revise first: 1.8 Concentration and Avogadro's law, 5.3 Rates of reaction and collision theory and 5.5 Reaction mechanisms and the rate-determining step
The rate equation and orders of reaction
A higher of a reactant usually makes a reaction faster (5.3). A says exactly how much faster, reactant by reactant.
For a reaction of A with B, the rate equation has the form below. Square brackets mean a concentration in .
In the equation above, is the with respect to A and the order with respect to B. The overall order is . is the , covered in the last section.
In IB questions every order is a whole number, usually 0, 1 or 2. Zero order means that reactant's concentration has no effect on the rate: , so A is left out of the rate equation.
Try it first, then reveal one step at a time.
- Read the orders from the powers: first order in , second order in , so third order overall.
- Halving multiplies the rate by .
- Tripling multiplies the rate by .
- Multiply the two factors: . Notice the orders do not match the coefficients 2 and 1 in the equation.
The balanced equation shows only the overall change. Most reactions go through several , and the slowest, the , sets the rate (5.5).
When the rate-determining step is the first step, each reactant's order is the number of its particles in that step. A reactant that only joins in after the rate-determining step is zero order. A catalyst that takes part in or before that step appears in the rate equation too, though it is not in the balanced equation.
Try it first, then reveal one step at a time.
- Point 1: where orders come from.
- Point 2: which step sets the rate.
- Point 3: how many take part in that step.
- Point 4: where the second reacts.
- Orders are found by experiment, not from the coefficients in the balanced equation. The rate depends only on the species in the rate-determining step, which is the slow step 1. Only one and one take part in step 1, so the reaction is first order in each. The second reacts in the fast step 2, after the rate-determining step, so it does not affect the rate.
A proposed mechanism must give the experimental rate equation. Agreement supports it but can't prove it, since another mechanism might fit the same data. So mechanisms are only ever possible mechanisms.
Deducing a rate equation from data
To find the order with respect to one reactant, change its concentration and keep everything else the same: the other concentrations, the temperature and any catalyst.
Then measure the initial rate, the rate at the very start, when you know every concentration. It is the gradient of the tangent to the concentration–time curve at , taken as positive.
Or put every other reactant in large excess, so only one concentration changes. Follow it over time and read its order from the graph's shape (next section).
1. Find two experiments in which only one concentration changes.
2. Work out the factor that concentration changes by, and the factor the rate changes by.
3. Match them using rate factor (concentration factor). For example, and are both second order. An unchanged rate means zero order.
4. Repeat for each reactant. Write the rate equation, leaving out any zero-order reactant.
Try it first, then reveal one step at a time.
- Experiments 1 and 2: only changes, by . The rate goes from to , also . So the reaction is first order in .
- Experiments 1 and 3: only changes, by . The rate goes from to , also . So it is first order in .
- The coefficient of is 2, but its order is 1: the data decide, not the equation.
Try it first, then reveal one step at a time.
- Experiments 1 and 2: , rate (to 3 s.f.). First order in .
- Experiments 1 and 3: , rate . First order in .
- Experiments 1 and 4: , rate , and . Second order in .
- Overall order . The orders of and (1 and 2) don't match their coefficients (5 and 6), so the reaction can't happen in a single step.
Graphs of zero, first and second order reactions
Two graphs show the with respect to a reactant A: against time, and rate against .
Zero order, : the rate stays the same as A is used up. So falls in a straight line, and rate against is a horizontal line.
First order, : rate against is a straight line through the origin. Against time, falls in a curve that keeps slowing. It always takes the same time to halve: the half-life is constant.
Second order, : rate against is an upward curve through the origin. Against time, drops steeply at first, then trails off slowly, and each half-life is longer than the one before.
On a concentration–time graph, the rate at any moment is the gradient of the tangent, taken as positive. For a zero-order reaction the gradient is the same everywhere, and its size equals .
Try it first, then reveal one step at a time.
- Straight line through the origin: rate is proportional to concentration, so . Water is in huge excess, so its concentration hardly changes.
- As the concentration falls, so does the rate, so the concentration–time graph curves and flattens.
- The rate is directly proportional to , so the reaction is first order with respect to . The concentration–time graph is a curve that gets less steep as the concentration falls. Its half-life is constant: the concentration halves in equal intervals of time.
Try it first, then reveal one step at a time.
- A straight concentration–time line has a constant gradient, so the rate doesn't change as falls. The reaction is zero order: .
- Why: the wire's surface is fully covered with ammonia, so extra ammonia can't react any faster.
- is the rate, the gradient taken as positive: .
- For zero order, has the same units as rate. Give 3 significant figures.
The rate constant and its units
The , , turns concentrations into a rate. At a fixed temperature it has one value for a reaction, whatever the concentrations.
To find , rearrange the rate equation and substitute the data from one experiment. Its units come from the same rearrangement: rate is in , and each concentration is in .
Overall order 0: . Order 1: . Order 2: . Order 3: . Each extra order adds .
Try it first, then reveal one step at a time.
- Rearrange: .
- Substitute: .
- Units: second order overall, so .
Try it first, then reveal one step at a time.
- Rearrange: .
- Substitute, squaring : .
- Units: overall order 4, so .
The same rules apply to halogenoalkanes reacting with hydroxide ions (6.18). A primary halogenoalkane, RX, has : second order, with in . A tertiary one has : first order, with in .
Common mistakes
- Taking orders from the coefficients in the balanced equation. Orders come only from experiment: in the order in is 1, not 2.
- Reading a rate that rises 4 times as order 4. The order is the power: in concentration giving in rate means , second order.
- Calling a straight-line concentration–time graph first order. It is zero order; first order gives a straight line through the origin on a rate–concentration graph.
- Leaving out the units of k, or giving it the units of rate. Work them out from the overall order.
Exam tips
- "Deduce" an order from data: name the two experiments you compare, and state the concentration factor and the rate factor before the order.
- "Calculate" : write the rearranged rate equation, substitute one experiment's values, then give the answer with its units.
- "Sketch" a rate–concentration or concentration–time graph: label both axes, and make the shape clear (straight or curved, through the origin or not).
Key takeaways
Practise this
108 past-paper questions on Rate laws, orders, Arrhenius and mechanisms in the Chemistry HL bank, each with a mark scheme and a worked explanation.