3. An object of mass 2m moving at velocity 3v collides with a stationary object of mass 4m. The objects stick together after the collision. What is the final speed and the change in total kinetic energy immediately after the collision? Final speed Change in total kinetic energy A. v 3 mv 2 B. v 6 mv 2 C. 2v 3 mv 2 D. 2v 6 mv 2
IB Physics SL · Topic practice
Mechanics and motion past paper questions
Connect kinematics and force models to graphs and free-body reasoning. Check sign conventions, units and whether the result matches the stated motion.
Appears inPaper 1 287Paper 2 51Paper 3 26
You’re practising 2016–2020 papers. The 2021–2026 papers, including 2026, need a plan.
Unlock from $6/mo4. An object of mass 1 kg is thrown downwards from a height of 20 m. The initial speed of the object is 6 m s–1. The object hits the ground at a speed of 20 m s–1. Assume g = 10 m s–2. What is the best estimate of the energy transferred from the object to the air as it falls? A. 6 J B. 18 J C. 182 J D. 200 J
Turn over 5. An object of mass 8.0 kg is falling vertically through the air. The drag force acting on the object is 60 N. What is the best estimate of the acceleration of the object? A. Zero B. 2.5 m s–2 C. 7.5 m s–2 D. 10 m s–2
6. P and Q leave the same point, travelling in the same direction. The graphs show the variation with time t of velocity v for both P and Q. Q P 0 0 1 2 3 4 5 6 7 8 20 40 v / m s–1 t / s What is the distance between P and Q when t = 8.0 s? A. 20 m B. 40 m C. 60 m D. 120 m
7. Three forces act on a block which is sliding down a slope at constant speed. W is the weight, R is the reaction force at the surface of the block and F is the friction force acting on the block. R W F In this situation A. there must be an unbalanced force down the plane. B. W = R. C. F = W. D. the resultant force on the block is zero.
8. A balloon rises at a steady vertical velocity of 10 m s–1. An object is dropped from the balloon at a height of 40 m above the ground. Air resistance is negligible. What is the time taken for the object to hit the ground? A. 10 s B. 5 s C. 4 s D. 2 s
Turn over 9. An object of mass m strikes a vertical wall horizontally at speed U. The object rebounds from the wall horizontally at speed V. What is the magnitude of the change in the momentum of the object? A. 0 B. m(V-U) C. m(U-V) D. m(U+V)
10. A horizontal force F acts on a sphere. A horizontal resistive force kv 2 acts on the sphere where v is the speed of the sphere and k is a constant. What is the terminal velocity of the sphere? A. k F B. k F C. F k D. F k
19. An electric motor raises an object of weight 500 N through a vertical distance of 3.0 m in 1.5 s. The current in the electric motor is 10 A at a potential difference of 200 V. What is the efficiency of the electric motor? A. 17 % B. 38 % C. 50 % D. 75 %
22. Mass M is attached to one end of a string. The string is passed through a hollow tube and mass m is attached to the other end. Friction between the tube and string is negligible. r m M Mass m travels at constant speed v in a horizontal circle of radius r. What is mass M? A. mv r 2 B. mv 2rg C. mgv r 2 D. mv gr 2
23. Planet X has a gravitational field strength of 18 N kg–1 at its surface. Planet Y has the same density as X but three times the radius of X. What is the gravitational field strength at the surface of Y? A. 6 m s–2 B. 18 m s–2 C. 54 m s–2 D. 162 m s–2
1. A company delivers packages to customers using a small unmanned aircraft. Rotating horizontal blades exert a force on the surrounding air. The air above the aircraft is initially stationary. aircraft package ground The air is propelled vertically downwards with speed v. The aircraft hovers motionless above the ground. A package is suspended from the aircraft on a string. The mass of the aircraft is 0.95 kg and the combined mass of the package and string is 0.45 kg. The mass of air pushed downwards by the blades in one second is 1.7 kg. (a) (i) State the value of the resultant force on the aircraft when hovering. [1] (ii) Outline, by reference to Newton’s third law, how the upward lift force on the aircraft is achieved. [2] (iii) Determine ν. State your answer to an appropriate number of significant figures. [3] (This question continues on the following page) Turn over (Question 1 continued) (b) The package and string are now released and fall to the ground. The lift force on the aircraft remains unchanged. Calculate the initial acceleration of the aircraft. [2]
2. The Rotor is an amusement park ride that can be modelled as a vertical cylinder of inner radius R rotating about its axis. When the cylinder rotates sufficiently fast, the floor drops out and the passengers stay motionless against the inner surface of the cylinder. The diagram shows a person taking the Rotor ride. The floor of the Rotor has been lowered away from the person. axis of rotation R (a) Draw and label the free-body diagram for the person. [2] (This question continues on the following page) Turn over (Question 2 continued) (b) The person must not slide down the wall. Show that the minimum angular velocity ω of the cylinder for this situation is g R where µ is the coefficient of static friction between the person and the cylinder. [2] (c) The coefficient of static friction between the person and the cylinder is 0.40. The radius of the cylinder is 3.5 m. The cylinder makes 28 revolutions per minute. Deduce whether the person will slide down the inner surface of the cylinder. [3]
2. A student studies the relationship between the centripetal force applied to an object undergoing circular motion and its period T. The object (mass m) is attached by a light inextensible string, through a tube, to a weight W which hangs vertically. The string is free to move through the tube. A student swings the mass in a horizontal, circular path, adjusting the period T of the motion until the radius r is constant. The radius of the circle and the mass of the object are measured and remain constant for the entire experiment. r hollow plastic tube m W The student collects the measurements of T fi ve times, for weight W. The weight is then doubled (2W) and the data collection repeated. Then it is repeated with 3W and 4W. The results are expected to support the relationship W mr T 4 2 2 . (a) State why the experiment is repeated with different values of W. [1] In reality, there is friction in the system, so in this case W is less than the total centripetal force in the system. A suitable graph is plotted to determine the value of mr experimentally. The value of mr was also calculated directly from the measured values of m and r. (b) Predict from the equation whether the value of mr found experimentally will be larger, the same or smaller than the value of mr calculated directly. [2] (This question continues on the following page) Turn over (Question 2 continued) (c) (i) The measurements of T were collected five times. Explain how repeated measurements of T reduced the random error in the final experimental value of mr. [2] (ii) Outline why repeated measurements of T would not reduce any systematic error in T. [1]
6. A bar rotates horizontally about its centre, reaching a maximum angular velocity in six complete rotations from rest. The bar has a constant angular acceleration of 0.110 rad s–2. The moment of inertia of the bar about the axis of rotation is 0.0216 kg m2. (a) Show that the final angular velocity of the bar is about 3 rad s–1. [2] (b) Draw the variation with time t of the angular displacement θ of the bar during the acceleration. [1] / rad θ t / s (c) Calculate the torque acting on the bar while it is accelerating. [1] (Option B continues on the following page) Turn over (Option B, question 6 continued) (d) The torque is removed. The bar comes to rest in 30 complete rotations with constant angular deceleration. Determine the time taken for the bar to come to rest. [2] (Option B continues on the following page) (Option B continued)
7. The first diagram shows a person standing on a turntable which can rotate freely. The person is stationary and holding a bicycle wheel. The wheel rotates anticlockwise when seen from above. A B turntable can rotate freely The wheel is flipped, as shown in the second diagram, so that it rotates clockwise when seen from above. A B (a) Explain the direction in which the person-turntable system starts to rotate. [3] (Option B continues on the following page) (Option B, question 7 continued) (b) Explain the changes to the rotational kinetic energy in the person-turntable system. [2]
Turn over 8. A solid sphere of radius r and mass m is released from rest and rolls down a slope, without slipping. The vertical height of the slope is h. The moment of inertia I of this sphere about an axis through its centre is 2 5 2 mr . r h Show that the linear velocity v of the sphere as it leaves the slope is 10 7 gh . [3] (Option B continues on the following page) (Option B continued)
3. A sky diver is falling at terminal speed when she opens her parachute. What are the direction of her velocity vector and the direction of her acceleration vector before she reaches the new terminal speed? Direction of velocity vector Direction of acceleration vector A. upwards upwards B. upwards downwards C. downwards upwards D. downwards downwards
3. The graph shows the variation of velocity of a body with time along a straight line. velocity time 0 0 P Q What is correct for this graph? A. The maximum acceleration is at P. B. The average acceleration of the body is given by the area enclosed by the graph and time axis. C. The maximum displacement is at Q. D. The total displacement of the body is given by the area enclosed by the graph and time axis.
3. Two forces act along a straight line on an object that is initially at rest. One force is constant; the second force is in the opposite direction and proportional to the velocity of the object. varying force constant force object What is correct about the motion of the object? A. The acceleration increases from zero to a maximum. B. The acceleration increases from zero to a maximum and then decreases. C. The velocity increases from zero to a maximum. D. The velocity increases from zero to a maximum and then decreases.
Mechanics and motion: quick facts
How often does Mechanics and motion come up in IB Physics SL?
Mechanics and motion is tagged on 364 of the 1,413 IB Physics SL past-paper questions on PastPaperPrep (26%), from papers sat 2016-2026. Paper 1 has the most Mechanics and motion questions, with 287. These are archive counts, not a prediction, and a question can carry more than one topic.
Are the IB Physics SL Mechanics and motion questions free?
142 of the 364 IB Physics SL Mechanics and motion questions are free to practise. The other 222 need a plan for IB Physics SL, from $6 a month.
Do the IB Physics SL Mechanics and motion questions have answers?
Yes. Each IB Physics SL Mechanics and motion question shows the official mark scheme answer. Many also have a step-by-step worked explanation written by PastPaperPrep.
Worked explanations
See the method, not just the answer
Many questions have an Explanation button next to the answer. It follows the question's free or paid access.
Practise mechanics and motionExample
Original example, not an exam question.
A car moving at 2 m s⁻¹ accelerates uniformly at 2 m s⁻² for 4 s. Find its final velocity and displacement.
- Final velocity. v = u + at = 2 + 2(4) = 10 m s⁻¹.
- Displacement. s = ut + ½at² = 2(4) + ½(2)(4²) = 24 m.
- Check. Average velocity × time = ½(2 + 10)(4) = 24 m.
“Every question for that one subtopic I kept failing, in one place.”