Electromagnetic spectrum
In a minute
Light is one of seven kinds of , from to . Learn their order, what each is used for, how each can harm you, and how satellites carry signals. Extended adds the speed , why each communication system uses its , and analogue versus .
You'll be able to
- Put the seven regions of the in order, both by and by .
- Recall that every electromagnetic wave travels at the same speed in a .
- Describe typical uses of each region, and the harm each can do to people after too much exposure.
- Recall that satellites communicate mainly using , and which satellite phones and TV use low orbit or geostationary satellites.
- Use for electromagnetic waves in a vacuum or air, and explain which waves phones, Wi-Fi, Bluetooth and use.
- Tell analogue and digital signals apart, and explain why digital signals carry more data further.
Before you start2 quick questions on what this builds on
Revise first: 2.3.3 Radiation, 3.1 General properties of waves, 3.2.2 Refraction of light and 3.2.4 Dispersion of light
The seven regions, in order
Light is not the only wave of its kind. It belongs to a family of , and most of them are invisible.
In order of increasing , lowest first: radio waves, microwaves and infrared; then visible light; then ultraviolet, and .
In order of increasing the list runs backwards, shortest first: gamma rays, X-rays and ultraviolet; then visible light; then infrared, microwaves and radio waves.
A memory aid for the frequency order: "Rabbits Mate In Very Unusual eXpensive Gardens". Visible light sits in the middle. Infrared is just beyond red, and ultraviolet is just beyond violet.
Every electromagnetic wave is a . In a they all travel at the same very high speed. Radio waves and gamma rays given out at the same moment by an exploding star reach a telescope in space at the same moment.
This is why the two orders are opposite. With and the same , a higher frequency means a shorter wavelength.
The speed of every electromagnetic wave in a vacuum is . In air it is almost exactly the same, so use in air too. You must remember this value.
Try it first, then reveal one step at a time.
- Write the whole spectrum, shortest wavelength first: gamma rays, X-rays and ultraviolet; then visible light; then infrared, microwaves and radio waves.
- Pick out the four regions in that order.
- Wavelength increases from gamma rays towards radio waves. So in order of increasing wavelength: gamma rays, ultraviolet, infrared, microwaves.
Try it first, then reveal one step at a time.
- Convert the frequency: .
- Rearrange : .
- Substitute: .
- Round to 2 significant figures, like the speed.
Try it first, then reveal one step at a time.
- The speed is not given, so recall it: in air.
- Rearrange : .
- Substitute: .
- Check the power of ten: dividing by adds 7 to the power, so becomes , and gives .
Uses and dangers of each region
Each region behaves differently: some pass through walls or skin, some are absorbed by water, some make special inks glow. That decides what each one is used for.
1. : radio and television broadcasts. Radio telescopes in astronomy detect radio waves from stars and galaxies. RFID (radio frequency identification) tags, in contactless cards, shop security tags and pet microchips, answer a reader using radio waves.
2. : satellite television, mobile phones (cell phones) and microwave ovens. In an oven, water in the food absorbs the microwaves and heats up.
3. Infrared: electric grills and toasters heat food with infrared. TV remote controls send short-range infrared signals. Intruder alarms detect the infrared from a warm body, and thermal imaging cameras show warmer objects brighter. Infrared also carries data in .
4. Visible light: seeing, photography and lighting (illumination).
5. : security marking with special ink that is invisible until it glows under an ultraviolet lamp. The same idea detects fake bank notes, because real notes carry ink that glows. Ultraviolet also sterilises water by killing bacteria.
6. : medical scanning, because X-rays pass through soft tissue but are absorbed by bone. Airport security scanners use them to see inside luggage.
7. : sterilising food and medical equipment by killing bacteria. In hospitals they are used to detect cancer and to treat it, by killing cancer cells.
Too much exposure to some regions harms people. Each harms in its own way, so learn them separately.
1. Microwaves heat body cells from the inside, as they heat food.
2. Infrared causes skin burns.
3. Ultraviolet damages surface cells of the skin and the eyes. This can lead to skin cancer and eye conditions such as cataracts.
4. X-rays and gamma rays pass deep into the body. They can damage cells or cause mutations (changes to a cell's DNA), which can lead to cancer.
Try it first, then reveal one step at a time.
- Give a precise use for each region, then name the damage and its result.
- X-rays are used to make images of bones, for example to find a fracture. Gamma rays are used to kill cancer cells, or to sterilise medical equipment. Too much exposure to either can damage cells deep in the body or cause mutations, which can lead to cancer.
Try it first, then reveal one step at a time.
- Say which cells ultraviolet damages, then the conditions that damage leads to.
- Ultraviolet damages the surface cells of the skin and the eyes. This can lead to skin cancer. It can also cause eye conditions such as cataracts.
Satellites and wireless communication
Artificial satellites orbit the Earth and relay signals around it. Communication with them is mainly by microwaves, which pass through the atmosphere easily.
A geostationary satellite orbits above the equator once every 24 hours, in the same direction as the Earth spins, so it keeps pace with the ground below and stays above the same point.
A dish pointed at a geostationary satellite never needs to move. Direct broadcast satellite television and some satellite phones use geostationary satellites.
Low orbit satellites are much closer to the Earth and cross the sky quickly. Some satellite phones use them; the phone links to whichever satellite is overhead.
Try it first, then reveal one step at a time.
- Link the type of satellite to what it does in the sky, then name the region.
- The TV signal comes from a geostationary satellite. It orbits above the equator once every 24 hours, in the same direction as the Earth spins, so it stays over one fixed spot on the Earth's surface. So a fixed dish always points at it. The signal is carried by microwaves.
Many everyday systems use electromagnetic waves. The reason for each choice is examined.
1. Mobile phones and wireless internet (Wi-Fi) use microwaves. Microwaves pass through some walls, and they need only a short aerial to send and receive.
2. Bluetooth uses radio waves. Radio waves get through walls, though they lose strength doing so. Bluetooth only links devices a few metres apart, so the weaker signal is still good enough.
3. Cable television and high-speed broadband use optical fibres carrying visible light or infrared. Glass lets visible light and some infrared through. Light and short-wavelength infrared can carry huge amounts of data each second.
Try it first, then reveal one step at a time.
- Give both reasons: what the waves can do, and what the phone needs to send and receive them.
- Microwaves can pass through some walls, so a phone works indoors. Microwaves need only a short aerial to send and receive them, so the aerial fits inside a small phone.
Analogue and digital signals Extended only
A signal carries information, such as speech or data. It can be analogue or digital.
Sound can be sent either way. A microphone turns sound into an analogue electrical signal that rises and falls like the sound wave. It can be sent like that, or converted into a stream of 1s and 0s and sent as a digital signal.
Every signal gets weaker and picks up random disturbances (noise) as it travels. So on a long journey it must be boosted at intervals along the way.
Boosting an analogue signal boosts the noise too, so noise builds up over a long distance. A digital signal only has to be read as 1 or 0, so a regenerator can rebuild it exactly, with the noise removed.
Digital signalling has two benefits. It can send data at a higher rate. It also has a greater range, because the signal can be regenerated accurately again and again.
Try it first, then reveal one step at a time.
- Say what happens to any signal on a long journey, then compare how each type is boosted.
- Any signal gets weaker and picks up noise as it travels. When an analogue signal is amplified, the noise is amplified too, so the noise builds up. A digital signal has only two values, 1 and 0. So it can be regenerated accurately, with the noise removed, and the signal can go much further.
Common mistakes
- Swapping the two orders. Fix one fact: radio waves have the longest wavelength and the lowest frequency. Then frequency rises, and wavelength falls, towards gamma rays.
- Saying higher-frequency waves are faster. In a vacuum every electromagnetic wave has the same speed; a higher frequency only means a shorter wavelength.
- Giving a vague use such as "medical". Say what is done: X-rays image bones, gamma rays kill cancer cells or sterilise equipment.
- Describing harm as just "dangerous". Name the damage: ultraviolet damages skin and eye cells, leading to skin cancer; X-rays and gamma rays damage cells or cause mutations.
- Losing the power of ten when dividing by a number like . Dividing by is the same as multiplying by .
Exam tips
- Spectrum chart questions (Paper 3/4): write the seven regions in order in the margin, and mark which end has the long wavelength, before you fill in the gaps or name the arrow's property.
- "Describe" a harmful effect: name the cells damaged and the result, such as "damages surface cells of the skin, leading to skin cancer".
- "Explain" the benefits of digital signals (Paper 4): give a higher data rate, then link the greater range to accurate regeneration because there are only two values.
Key takeaways
Practise this
58 past-paper questions on Electromagnetic spectrum in the 0625 Extended bank, each with a mark scheme and a worked explanation.