3.2.2 · CorePaper 1Paper 2Paper 3Paper 4Paper 5Paper 6

Refraction of light

In a minute

Light bends when it crosses into a material where its speed is different. Learn the and the two angles, the glass-block experiment, the and . Extended adds and .

You'll be able to

  • Define the normal, the angle of incidence and the angle of , and use them to describe how light bends at a boundary.
  • Describe an experiment that traces rays of light through transparent blocks of different shapes.
  • State what the critical angle is, and describe internal and total internal reflection with experiments and everyday examples.
  • Define refractive index as a ratio of speeds, and use n=sin⁡isin⁡rn = \frac{\sin i}{\sin r} and n=1sin⁡cn = \frac{1}{\sin c}.
  • Describe how optical fibres carry light and why they are used in telecommunications.
Before you start2 quick questions on what this builds on
Check yourself
A wave moves into a region where it travels more slowly. Which quantity stays the same?
Check yourself
When light reflects from a flat mirror, which line are the angles measured from?

Revise first: 3.1 General properties of waves and 3.2.1 Reflection of light

Light crossing a boundary

Light travels in straight lines through one material. Its speed depends on the material: it is slower in glass, water or clear plastic than in air. When light crosses a boundary at an angle, the change of speed makes it change direction. This is .

To describe the bending, draw the where the ray meets the boundary. Measure every angle from the normal, never from the surface.

A ray of light bends towards the normal entering a glass block and away from the normal leaving it, coming out parallel to its original direction; a ray along the normal goes straight through air glass air i r normal leaves parallel to the ray that went in along the normal: no change of direction dashed lines: normals, at 90° to the surface
The ray bends towards the normal going in and away from it coming out.

Into a material where light is slower (air into glass), the ray bends towards the normal, so rr is smaller than ii.

Into a material where light is faster (glass into air), it bends away from the normal: rr is bigger than ii.

A ray along the normal changes speed but not direction.

Through a rectangular block with air on both sides, a ray that comes out of the opposite face bends one way going in and back the same amount coming out. It leaves parallel to the ray that went in, shifted sideways.

At every boundary the frequency of the light stays the same. Its speed and its change. Some light is also reflected at the boundary, so a faint reflected ray is often seen too.

Worked exampleA narrow beam of light hits the top face of a glass block, making 34∘34^\circ with that face. Find the angle of incidence.

Try it first, then reveal one step at a time.

  1. The angle of incidence is measured from the normal, which is at 90∘90^\circ to the surface.
Worked exampleA narrow ray of light in air strikes one face of a rectangular glass block at an angle. It passes through the block and out of the opposite face. Describe the path of the ray.

Try it first, then reveal one step at a time.

  1. Describe each boundary in turn: what happens to the speed, and which way the ray bends compared with the normal.
Check yourself
A ray of light passes at an angle from water into air. Which statement is correct?
Check yourself
A ray of light enters a glass block along the normal. What happens to it?

Experiment: rays through blocks

You need a ray box (a lamp with a narrow slit), transparent blocks of different shapes, white paper, a sharp pencil, a ruler and a protractor.

Rectangular block: the ray bends going in and coming out. If it leaves through the opposite face, it comes out parallel to its first direction.

Triangular prism: the ray bends at both faces, both times towards the thicker part of the prism, so it comes out in a new direction.

Semicircular block: aim the ray at the centre of the flat face, through the curved face. It enters along a radius, which is a normal, so it bends only at the flat face.

Worked exampleDescribe an experiment to show how a ray of light is refracted by a transparent block. Include how you would measure the angles.

Try it first, then reveal one step at a time.

  1. Paper 6 rewards each step in order: set up, mark the rays, draw the path, draw the normals, measure, repeat.
Check yourself
Why should the two crosses marking a ray be placed far apart?

Critical angle and total internal reflection

Light inside glass meeting the boundary with air at a small angle of incidence splits in two. Most refracts out, bending away from the normal. A little reflects back into the glass: this is internal reflection.

Make the angle of incidence bigger and the ray that gets out bends further from the normal and grows dimmer. The internally reflected ray grows brighter.

At one angle of incidence, the refracted ray runs along the boundary: the angle of refraction is 90∘90^\circ. That angle of incidence is the , cc. For glass it is about 42∘42^\circ, and for water about 49∘49^\circ.

Above the critical angle no light refracts out. All of it reflects back inside: . It follows the law of reflection, so the angle of reflection equals the angle of incidence.

Total internal reflection needs both conditions: the light is heading into a material where it would be faster (glass or water into air), and the angle of incidence is greater than the critical angle. Light going from air into glass is never totally internally reflected.

Light inside a semicircular glass block meets the flat face: below the critical angle it mostly refracts out, at the critical angle it runs along the surface, above it all of it is reflected back refracted out; weak reflection i i less than c air glass refracted ray along the surface 90° i i equal to c air glass all light reflected: TIR i i greater than c air glass
Increase the angle of incidence inside the glass. At the critical angle the refracted ray runs along the surface; beyond it, all the light reflects.

To show this, aim a ray through the curved face of a semicircular block at the centre of its flat face. Turn the block a little at a time to increase the angle of incidence and watch the ray that gets out. Mark the position where it just runs along the flat face. The angle of incidence there is the critical angle.

Everyday examples. Prism periscopes and binoculars: light meets the long face of a 45∘45^\circ right-angled glass prism at 45∘45^\circ, which is more than 42∘42^\circ, so it is totally reflected. Diamonds sparkle because light is totally reflected many times inside before it leaves. Under water, you see the surface above you shine like a mirror when you look up at a slant.

Worked exampleA ray of light travels inside a clear plastic block and meets the boundary with the air. Its angle of incidence is 52∘52^\circ. The critical angle for this plastic is 39∘39^\circ. Describe what happens to the ray at the boundary, and explain why.

Try it first, then reveal one step at a time.

  1. Check both conditions: the direction the light is travelling, and how the angle of incidence compares with the critical angle.
Check yourself
Which conditions give total internal reflection?
Check yourself
Under water, a ray meets the water surface at 27∘27^\circ to the normal. The critical angle for water is 49∘49^\circ. What happens to the ray?

Refractive index Extended only

A material's , nn, tells you how much it slows light down.

Learn this
n=speed in airspeed in the materialn = \frac{\text{speed in air}}{\text{speed in the material}}

nn is a ratio of two speeds, so it has no unit. Light is always slower in glass or water than in air, so their nn is greater than 1: about 1.51.5 for glass and 1.331.33 for water.

Learn this
n=sin⁡isin⁡rn = \frac{\sin i}{\sin r}

Here ii is the angle in air and rr the angle in the material, both measured from the normal.

Worked exampleLight crosses from air into a clear plastic sheet. Measured from the normal, the ray makes 55.0∘55.0^\circ in the air and 34.0∘34.0^\circ in the plastic. Calculate the refractive index of the plastic.

Try it first, then reveal one step at a time.

  1. Write the equation: n=sin⁡isin⁡rn = \frac{\sin i}{\sin r}.
Learn this
n=1sin⁡cn = \frac{1}{\sin c}

This links the critical angle cc to nn. A bigger refractive index gives a smaller critical angle.

Worked exampleDiamond has a refractive index of 2.422.42. Calculate the critical angle for light inside a diamond.

Try it first, then reveal one step at a time.

  1. Rearrange n=1sin⁡cn = \frac{1}{\sin c}: sin⁡c=1n\sin c = \frac{1}{n}.
Check yourself
Light travels at 3.0×108 m/s3.0 \times 10^8\ \text{m/s} in air and 2.25×108 m/s2.25 \times 10^8\ \text{m/s} in water. What is the refractive index of water, to 2 decimal places?
Check yourself
A ray passes from air into glass of refractive index 1.501.50. The angle of incidence is 36∘36^\circ. What is the angle of refraction?

Optical fibres Extended only

An is a thin, flexible strand of very clear glass. Light entering one end nearly along the fibre meets the side with an angle of incidence bigger than the critical angle, so it is totally internally reflected. It zig-zags along the fibre, even round gentle bends, and almost none escapes.

A ray of light zig-zags along a glass optical fibre, totally internally reflected each time it meets the side i light is totally internally reflected each time it meets the side i is greater than the critical angle, so no light escapes glass fibre light in
Each reflection is total, so the light stays inside the fibre.

In telecommunications, fibres carry telephone calls, internet data and television as fast pulses of light, often infrared. Compared with copper cables, they carry much more information, lose less of the signal over long distances and pick up no electrical interference. Doctors also use bundles of fibres in an endoscope to see inside the body.

Worked exampleExplain how a signal travels along an optical fibre, and give two reasons why optical fibres are used for long-distance internet links.

Try it first, then reveal one step at a time.

  1. Say what happens each time the light meets the side, and why. Then compare fibres with copper cables.
Check yourself
Why does light stay inside an optical fibre?

Common mistakes

  • Drawing a ray straight on through a boundary it meets at an angle. It must bend: towards the normal going into glass or water, away from it coming out.
  • Marking or calculating an angle from the surface instead of the normal.
  • Saying the frequency changes when light enters glass. Only the speed and the wavelength change.
  • Drawing a refracted ray out of the glass when the angle of incidence is greater than the critical angle. Draw only the reflected ray, at the same angle to the normal.

Exam tips

  • "State the meaning of critical angle": name the angle of incidence (inside the slower material, such as glass) and say the angle of refraction is then 90∘90^\circ. Both points earn marks.
  • Ray diagrams: use a ruler, put arrows on the rays, draw the normal dashed and at 90∘90^\circ to the surface, and label angles between the ray and the normal.
  • For total internal reflection, the reflected ray must make the same angle with the normal as the incident ray, with no ray drawn out into the air.

Key takeaways

Learn thisNormal: a line at 90∘90^\circ to the surface where the ray meets it. The angles of incidence and refraction are measured from the normal, never from the surface.
Learn thisInto a material where light is slower (air into glass): bends towards the normal. Into one where it is faster (glass into air): bends away. Along the normal: no change of direction. The frequency never changes.
Learn thisCritical angle: the angle of incidence, for light going into a material where it is faster, at which the angle of refraction is 90∘90^\circ.
Learn thisTotal internal reflection: light heading into a material where it would be faster is all reflected back when its angle of incidence is greater than the critical angle. Examples: prism periscopes and binoculars, sparkling diamonds.
Learn thisn=speed in airspeed in the material(refractive index, no unit)n = \frac{\text{speed in air}}{\text{speed in the material}} \quad \text{(refractive index, no unit)}
Learn thisn=sin⁡isin⁡r(i in air, r in the material)n = \frac{\sin i}{\sin r} \quad \text{(}i\text{ in air, }r\text{ in the material)}
Learn thisn=1sin⁡c(c: critical angle, material to air)n = \frac{1}{\sin c} \quad \text{(}c\text{: critical angle, material to air)}
Learn thisOptical fibres keep light inside by total internal reflection. In telecommunications they carry more information than copper cables, with less loss and no electrical interference.

Practise this

83 past-paper questions on Refraction of light in the 0625 Extended bank, each with a mark scheme and a worked explanation.

Practise Refraction of light →