2.2.1 · CorePaper 1Paper 2Paper 3Paper 4

Thermal expansion of solids, liquids and gases

In a minute

Heat almost anything and it gets slightly bigger; cool it and it shrinks. This is . For the same rise, a at constant pressure expands the most and a the least. It is why bridges have gaps and overhead cables sag, and how a thermometer and a thermostat work.

You'll be able to

  • Describe what happens to the size, mass and of a solid, or gas when it is heated or cooled.
  • Put solids, liquids and gases in order of how much they expand for the same temperature rise.
  • Describe everyday problems that expansion causes, and uses of expansion such as thermometers and bimetallic strips.
  • Explain, using the forces between particles and their motion, why gases expand most and solids least.
Before you start3 quick questions on what this builds on
Check yourself
A stone has a mass of 72 g72\ \text{g} and a volume of 30 cm330\ \text{cm}^3. What is its , in g/cm³?
Check yourself
In which state of matter are the particles furthest apart?
Check yourself
A metal block is warmed. What happens to its particles?

Revise first: 1.4 Density, 2.1.1 States of matter and 2.1.2 Particle model

Heating makes things expand

A tight metal lid on a glass jar often comes loose after a minute under the hot tap. The hot metal has grown slightly bigger. Almost every substance expands when it is heated and contracts (gets smaller) when it cools.

Using the : heating gives the particles more kinetic energy. They vibrate or move faster, so on average they sit a little further apart, and the substance takes up more space. The particles themselves do not get any bigger.

A gets longer, wider and thicker. A hole in a solid gets bigger too, because all the material around it expands. A fills a bigger volume, so its level climbs a narrow tube.

A expands when it is heated at constant pressure, for example in a balloon or behind a plunger that can slide freely. If the gas is sealed in a rigid container, it cannot expand, so its pressure rises instead (2.1.3).

Heating neither adds nor removes particles, so the mass does not change. The same mass now fills a bigger volume, so the , ρ=mV\rho = \frac{m}{V}, decreases.

The amount of expansion depends on the state. For the same temperature rise, a gas at constant pressure expands far more than a liquid does. A liquid expands more than a solid, and a solid expands so little that you rarely see it change size.

Worked exampleA brass ball can just pass through a brass ring when both are at room temperature. The ball alone is then heated strongly in a flame. Describe what happens when you try to pass the ball through the ring again, and explain it in terms of particles.

Try it first, then reveal one step at a time.

  1. Say what happens to the size of the ball, then what its particles do, then what happens when it cools.
Worked exampleA thin soap film is stretched across the open neck of an empty glass bottle. The bottle is stood in a bowl of hot water, and the film bulges outwards into a dome. Explain why.

Try it first, then reveal one step at a time.

  1. Decide which part expands most: the air or the glass. Then say what the air particles do.
Check yourself
A steel washer is a flat ring with a hole in the middle. The whole washer is heated evenly. What happens to the diameter of the hole?
Check yourself
A block of wax is warmed gently. It expands but does not melt. What happens to its mass and its density?
Check yourself
Equal volumes of air, water and copper are each warmed by 15 °C15\ \text{°C}. The air is kept at constant pressure. Which expands the most?

Expansion in everyday life

Expansion is small, but a solid that is stopped from expanding pushes with very large forces. Structures must leave room for it:

1. Railway tracks and concrete roads have small gaps between sections, and bridges have expansion joints. On hot days the sections expand into the gaps instead of buckling or cracking.

2. Overhead power cables are hung with some slack. In cold weather they contract and pull tighter, so cables hung tight could snap. In hot weather they expand and sag lower.

3. Long pipes carrying hot water or steam include loops or bends, which flex as the pipe gets longer.

Expansion is also useful. In a liquid-in-glass thermometer, the liquid expands much more than the glass. The tube is very narrow, so a small increase in volume gives a long rise up the tube.

A bimetallic strip is two different metals, such as brass and iron, joined along their length. When it is heated, the brass expands more than the iron. The strip can only fit both lengths by bending, with the brass on the outside of the curve.

Two drawings of a bimetallic strip made of brass bonded on top of iron, clamped at its left end. Cold, the strip is straight. Heated, it bends downwards, with the brass on the outside of the curve, because brass expands more than iron cold: straight heated: bends brass iron clamp brass: expands more, on the outside of the curve iron: expands less, on the inside
Brass expands more than iron, so a heated bimetallic strip bends with the brass on the outside.
Worked exampleA long steel road bridge has an expansion joint at one end: two sets of metal teeth that slide past each other, leaving a gap that can open and close. Explain why the bridge needs this joint.

Try it first, then reveal one step at a time.

  1. Deal with hot days and cold days in turn, then say what would happen with no joint.
Worked exampleThe thermostat in an electric heater uses a bimetallic strip of brass and iron. When the strip is cool, it touches a contact and completes the heater's circuit. Brass expands more than iron. Describe how the strip switches the heater off when the room becomes too warm, and on again when it cools.

Try it first, then reveal one step at a time.

  1. Say which metal expands more, which way the strip bends, and what that does to the circuit.
Check yourself
Overhead power cables hang between two pylons. When do they hang lowest?
Check yourself
A metal lid is stuck on a glass jar. Holding the lid under hot water often loosens it. Why?

Why gases expand most and solids least Extended only

Heating makes the particles of every state move faster. The amount of expansion depends on how strongly the particles are held together.

1. Solid: strong attractive forces hold the particles close together in fixed positions. They vibrate more, but the forces keep them close, so a solid expands least.

2. Liquid: the particles are still close together, but the forces between them are weaker, and they can move around each other. Extra motion pushes them apart more easily, so a liquid expands more than a solid.

3. Gas: the particles are far apart and the forces between them are very weak. Nothing holds them together, so as they speed up the gas spreads out much more (at constant pressure).

Worked exampleWarming by 10 °C10\ \text{°C} makes the air in a gas syringe with a free plunger expand by about 3%. The same rise makes a steel rod expand by well under 0.1% of its volume. Explain this difference in terms of particles.

Try it first, then reveal one step at a time.

  1. Compare the forces between the particles in each, and say what those forces do when the particles move faster.
Check yourself
Which statement explains why a liquid expands more than a solid for the same temperature rise?
Check yourself
In sample X the particles are in a regular, closely packed pattern. In sample Y they are close together but randomly arranged. In sample Z they are far apart. All three are warmed by the same amount, with Z at constant pressure. Which sample expands the least?

Common mistakes

  • Saying the particles get bigger when a substance is heated. They stay the same size; they move faster and spread further apart.
  • Thinking the hole in a heated ring or nut gets smaller. All of the metal expands, so the hole gets bigger too.
  • Saying the mass increases as a substance expands. No particles are added, so the mass stays the same and the density falls.
  • Linking the most ordered particles with the most expansion. Tightly held particles in a solid give the least expansion; widely spaced gas particles give the most.

Exam tips

  • "Describe" an application of expansion: say whether the object gets hotter or colder, whether it expands or contracts, and what problem this causes or what job it does.
  • When asked about mass and density on heating, give both: the mass stays the same and the density decreases, because the volume increases.

Key takeaways

Learn thisAlmost all substances expand when heated and contract when cooled (a gas in a rigid, sealed container cannot expand: its pressure rises instead). The mass stays the same, so as a substance expands its density decreases.
Learn thisWhen a substance expands on heating, its particles move or vibrate faster and spread further apart on average. The particles themselves do not get bigger.
Learn thisFor the same temperature rise, a gas at constant pressure expands the most, a liquid less, and a solid the least.
Learn thisAllowing for expansion: gaps in railway tracks and roads, expansion joints in bridges and slack in overhead cables leave room for expansion and contraction. Uses: liquid-in-glass thermometers and bimetallic strips in thermostats.
Learn thisA heated bimetallic strip bends with the metal that expands more on the outside of the curve.
Learn thisSolids expand least because strong forces hold their particles in fixed positions. Gases (at constant pressure) expand most because the forces between their particles are very weak.

Practise this

9 past-paper questions on Thermal expansion of solids, liquids and gases in the 0625 Extended bank, each with a mark scheme and a worked explanation.

Practise Thermal expansion of solids, liquids and gases →