2.1.3 · CorePaper 1Paper 2Paper 3Paper 4

Gases and the absolute scale of temperature

In a minute

A sealed pushes harder on its container when it is heated in a fixed volume, or squeezed into less space at constant , because its particles hit the walls more often (and, when hotter, harder). Scientists also measure from , in : add 273 to a Celsius temperature. Extended adds , pV=constantpV = \text{constant}.

You'll be able to

  • Describe, in terms of particles, how heating or cooling a sealed gas in a fixed volume changes its .
  • Describe, in terms of particles, how squeezing or expanding a gas at constant temperature, with no gas escaping, changes its pressure.
  • Convert temperatures between degrees Celsius and kelvin with T=θ+273T = \theta + 273.
  • Use pV=constantpV = \text{constant} when a fixed mass of gas is kept at constant temperature, and sketch its graphs.
Before you start3 quick questions on what this builds on
Check yourself
A force of 60 N60\ \text{N} acts at right angles to an area of 0.20 m20.20\ \text{m}^2. What is the pressure?
Check yourself
What causes the pressure that a gas exerts on the walls of its container?
Check yourself
What is absolute zero?

Revise first: 1.8 Pressure, 2.1.1 States of matter and 2.1.2 Particle model

Why the pressure of a gas changes

Put your finger over the end of a bicycle pump and push the handle in: the trapped air pushes back harder and harder. An aerosol can says "do not heat": warming the gas inside raises its pressure, and the can could burst.

In both, the mass of gas is fixed: no gas gets in or out, yet its pressure changes. The particles of a gas move quickly in random directions, and each one that hits a wall pushes on it. The is the force of all these collisions on each unit area of wall.

So the pressure rises if the particles hit the walls more often, or hit them harder. Everything in this section comes from those two ideas.

First, heat a gas in a sealed, rigid container, so its volume can't change. Its temperature rises, so its particles move faster on average: their average kinetic energy increases. They hit the walls more often, and harder each time, so the pressure increases. Cooling does the opposite: the particles slow down and the pressure falls.

Worked exampleA steel diving cylinder full of air is left in hot sunshine on the deck of a boat. Its volume does not change. Explain, in terms of particles, why the pressure of the air inside increases.

Try it first, then reveal one step at a time.

  1. Start with the temperature, then the particles' speed, then the two ways their collisions with the walls change.

Next, keep the temperature the same and push a piston in slowly, so the gas has a smaller volume. The temperature hasn't changed, so the particles' average speed doesn't change. But the same particles now share less space, so each one has less distance to travel between hits on the walls. The walls are hit more often, so the pressure increases. Let the gas expand into a larger volume and the walls are hit less often: the pressure falls.

Two identical cylinders with the same eight gas particles sealed in by a piston. On the left the piston is pulled out and the gas has a large volume. On the right the piston is pushed halfway in at the same temperature, so the same particles are crowded into half the volume and hit the walls more often larger volume half the volume, same temperature further to travel between hits more hits on the walls each second same number of particles in both
Same particles, same average speed, less space: more collisions with the walls each second.
Worked exampleA student holds a finger over the outlet of a bicycle pump and pushes the handle in slowly, so the temperature of the trapped air stays the same. Explain, in terms of particles, why the pressure of the trapped air increases.

Try it first, then reveal one step at a time.

  1. Say what stays the same (the speed), what changes (the volume), and what that does to the collisions with the walls.
Check yourself
A sealed glass flask of air is carried from a warm laboratory into a cold room. Its volume stays the same. Why does the pressure of the air inside fall?
Check yourself
Air is sealed in a syringe. The plunger is pulled out slowly, so the temperature of the air stays constant. What happens?

The kelvin scale

The Celsius scale puts 0 °C0\ \text{°C} at the melting point of ice. Much colder temperatures exist, so Celsius temperatures can be negative. The coldest possible temperature is , about −273 °C-273\ \text{°C}, where the particles have the least possible kinetic energy.

The scale (the absolute scale of temperature) starts at absolute zero, 0 K0\ \text{K}. A change of one kelvin is the same size as a change of one degree Celsius, so the two scales are shifted by 273:

Learn this
T (in K)=θ (in °C)+273T\ (\text{in K}) = \theta\ (\text{in °C}) + 273

To go back to Celsius, subtract: θ=T−273\theta = T - 273. For example, ice melts at 0 °C=273 K0\ \text{°C} = 273\ \text{K} and water boils at 100 °C=373 K100\ \text{°C} = 373\ \text{K}. A kelvin temperature is never negative.

Worked exampleLiquid nitrogen boils at −196 °C-196\ \text{°C}. Convert this temperature to kelvin.

Try it first, then reveal one step at a time.

  1. Write the equation: T=θ+273T = \theta + 273.
Worked exampleA sensor in a pizza oven reads 658 K658\ \text{K}. What is this temperature in degrees Celsius?

Try it first, then reveal one step at a time.

  1. Rearrange T=θ+273T = \theta + 273 for the Celsius temperature: θ=T−273\theta = T - 273.

A temperature change is the same number on both scales. Warming from 20 °C20\ \text{°C} to 35 °C35\ \text{°C} is a rise of 15 °C15\ \text{°C}, which is also a rise of 15 K15\ \text{K}. Don't add 273 to a change.

Check yourself
A classroom is at 22 °C22\ \text{°C}. What is this temperature in kelvin?
Check yourself
A cup of tea cools from 80 °C80\ \text{°C} to 45 °C45\ \text{°C}. By how much does its temperature fall, in kelvin?

Boyle's law: pressure and volume Extended only

Squeezing a gas raises its pressure. For a fixed mass of gas kept at a constant temperature, the link is exact: halve the volume and the pressure doubles. Pressure × volume stays the same. This is .

Learn this
pV=constantpV = \text{constant}

Here pp is the pressure and VV is the volume. For a change from a first state to a second, p1V1=p2V2p_1 V_1 = p_2 V_2. Use the same units on both sides (kPa and cm³ are fine); you don't need to convert to Pa and m³.

Worked exampleA syringe holds 45 cm345\ \text{cm}^3 of air at a pressure of 100 kPa100\ \text{kPa}. The outlet is sealed and the plunger is pushed in slowly until the volume is 18 cm318\ \text{cm}^3. The temperature stays constant. Calculate the new pressure of the air.

Try it first, then reveal one step at a time.

  1. Write the equation: p1V1=p2V2p_1 V_1 = p_2 V_2.
Worked exampleA diver breathes out a bubble of air with a volume of 1.6 cm31.6\ \text{cm}^3 at a depth where the pressure is 330 kPa330\ \text{kPa}. The bubble rises to the surface, where the pressure is 101 kPa101\ \text{kPa}. Assume the temperature of the air does not change. Calculate the volume of the bubble at the surface.

Try it first, then reveal one step at a time.

  1. Write the equation and rearrange for the new volume: p1V1=p2V2p_1 V_1 = p_2 V_2, so V2=p1V1p2V_2 = \frac{p_1 V_1}{p_2}.

Rearranged, Boyle's law says p=constantVp = \frac{\text{constant}}{V}: pressure is inversely proportional to volume. So a graph of pp against VV is a curve: double VV and pp halves. A graph of pp against 1V\frac{1}{V} is a straight line through the origin.

Two graphs for a fixed mass of gas at constant temperature. Left: pressure against volume is a curve that falls steeply at small volumes and then levels off, never touching either axis. Right: pressure against 1 over volume is a straight line through the origin 0 pressure p volume V 0 pressure p 1 / V a curve: double V, p halves a straight line through the origin
Boyle's law: pp against VV is a curve; pp against 1V\frac{1}{V} is a straight line through the origin.
Check yourself
Boyle's law: which of these graphs is straight and passes through the origin?
Check yourself
A sealed sample of gas occupies 600 cm3600\ \text{cm}^3 at 90 kPa90\ \text{kPa}. It is compressed at constant temperature until its pressure is 150 kPa150\ \text{kPa}. What is its new volume, in cm³?

Common mistakes

  • Subtracting 273 to change °C into K, or adding it to change K into °C. Kelvin numbers are the bigger ones: add 273 to a Celsius temperature.
  • Saying gas particles move faster when the gas is squeezed at constant temperature. Their average speed stays the same; they just hit the walls more often.
  • Explaining gas pressure with particles colliding "with each other". Pressure comes from the particles colliding with the walls of the container.
  • Adding 273 to a temperature change. A rise of 15 °C is a rise of 15 K.

Exam tips

  • "Explain" a pressure change "in terms of particles" in linked steps: the particles' average speed, how often they hit the walls, the force on the walls, then the pressure. Say what stays constant.
  • "Convert" a temperature: write T=θ+273T = \theta + 273, substitute, and give the unit K (never °K).

Key takeaways

Learn thisFixed mass of gas, constant volume: a higher temperature makes the particles move faster on average, so they hit the walls more often and harder, and the pressure increases.
Learn thisFixed mass of gas, constant temperature: a smaller volume means the particles, at the same average speed, hit the walls more often, so the pressure increases.
Learn thisT (in K)=θ (in °C)+273T\ (\text{in K}) = \theta\ (\text{in °C}) + 273, and θ=T−273\theta = T - 273. Absolute zero is 0 K0\ \text{K}; kelvin temperatures are never negative. A change of 1 K equals a change of 1 °C.
Learn thisBoyle's law: when a fixed mass of gas is kept at a constant temperature, pV=constantpV = \text{constant}, so p1V1=p2V2p_1 V_1 = p_2 V_2. A graph of pp against VV is a curve; pp against 1V\frac{1}{V} is a straight line through the origin.

Practise this

37 past-paper questions on Gases and the absolute scale of temperature in the 0625 Extended bank, each with a mark scheme and a worked explanation.

Practise Gases and the absolute scale of temperature →