Pressure, amount of substance and the ideal gas model
In a minute
A pushes on every surface it touches, and that push per unit area is its . You count the molecules doing the pushing in , using the . The model explains three gas laws found by experiment, which combine into one: is constant for a fixed amount of gas.
You'll be able to
- Calculate a pressure from a and an area, using only the part of the force perpendicular to the surface.
- Convert between a number of molecules and an in moles.
- List what the ideal gas model assumes about molecules, and outline how a real gas differs.
- Explain gas pressure, and each gas law, in terms of molecules hitting the container walls.
- Use the constant-temperature, constant-pressure and constant-volume gas laws, and show how they combine into .
- Represent changes of a gas as lines and curves on a pressure–volume diagram.
Before you start3 quick questions on what this builds on
Revise first: 1.4 Newton's laws and free-body diagrams, 2.1 Particles, density and temperature and 6.1 Units, measurement and estimation
Pressure
Push a drawing pin into a board. Your thumb and the board feel the same force, yet only the point goes in. At the point, the force is spread over a tiny area, so the push on each square millimetre is enormous.
is given by this data booklet equation.
is the force perpendicular to the surface, in N, and is the area in . The unit is the pascal: . Air at sea level is at about ; a question gives the value when you need it.
Only the perpendicular part of a force presses on a surface. For a force at an angle to the surface, that component is . The parallel component slides along the surface and adds nothing to the pressure.
Try it first, then reveal one step at a time.
- The weight acts straight down on a horizontal floor, so all of it is perpendicular to the surface.
- Convert the area: .
- Substitute: , to 2 significant figures like the area.
Try it first, then reveal one step at a time.
- Find the perpendicular component: .
- Substitute: , which is to 2 significant figures.
- Check: the whole would give , too big, because part of the push slides along the glass.
Amount of substance and the mole
A breath of air holds about molecules. Numbers that big are awkward, so physicists count particles in fixed bundles, the way eggs come in dozens. The bundle is the .
is the , given in the data booklet like every constant in this lesson. The is the number of particles measured in moles.
is a plain count, so comes out in mol. To go the other way, use . If a question gives the molar mass , the mass of one mole, then .
Try it first, then reveal one step at a time.
- Use .
- Substitute: , to 2 significant figures like the count.
Try it first, then reveal one step at a time.
- Find the amount: .
- Count the atoms: .
The ideal gas model
Tracking billions of tugging, tumbling molecules is impossible. So the kinetic theory uses a model: a huge number of tiny particles in random motion. The is the gas this model describes exactly.
1. A very large number of identical molecules move randomly in all directions.
2. The molecules' own volume is negligible compared with the container's. They behave as points.
3. There are no intermolecular forces except during collisions, so molecules move in straight lines between collisions.
4. Collisions are elastic: no is lost. Each lasts a negligible time compared with the time between collisions.
With no intermolecular forces there is no intermolecular potential energy. So the of an ideal gas is all random kinetic energy, and an ideal gas can never be liquefied.
The model explains pressure. A molecule bouncing off a wall reverses its momentum towards the wall. That needs a force from the wall, so by Newton's third law the molecule pushes the wall back. Countless collisions per second give a steady force per unit area: the pressure.
Faster molecules hit harder, and more frequent hits push more, so both raise the pressure. Temperature fits too: from 2.1, absolute temperature measures the average kinetic energy of the molecules. 2.8 turns this picture into equations.
No real gas is ideal. Real molecules take up some space and attract each other weakly, so a real gas has some intermolecular potential energy and liquefies when cooled enough. It obeys the gas laws only approximately, best at low pressure and and high temperature (2.8).
Try it first, then reveal one step at a time.
- Start with what the molecules do, then link each hit to a change in momentum and a force.
- Finish with many collisions and force per unit area.
- The air molecules move randomly at high speed and keep colliding with the lid. In each collision the molecule's momentum towards the lid reverses, so its momentum changes. A change in momentum needs a force, so the lid exerts a force on the molecule. By Newton's third law the molecule exerts an equal and opposite force on the lid. Huge numbers of collisions every second give a steady average force on the lid. The pressure is this force per unit area of the lid.
Try it first, then reveal one step at a time.
- Compare each assumption of the model with what neon atoms really do.
- Give each difference its own sentence, with its consequence.
- Neon atoms have a small but non-zero volume, while the particles of an ideal gas are points with negligible volume. Neon atoms also attract each other weakly, so neon has some intermolecular potential energy, while an ideal gas has none. Because of these attractions, neon can be liquefied if it is cooled enough, which an ideal gas never can.
The gas laws and pV diagrams
A fixed amount of gas has a pressure , a volume and a temperature . Experimenters held one constant and varied the other two. The laws they found from these measurements are called empirical.
At constant temperature (Boyle's law), , so is constant. Halve the volume and the pressure doubles.
At constant pressure (Charles's law), , so is constant. At constant volume (the pressure law), , so is constant.
In both temperature laws must be in kelvin. Only a scale starting at absolute zero gives a line through the origin.
Each law has a molecular reason. Squeeze the gas at constant temperature and the molecules, at the same speed, hit each square metre of wall more often. Heat it at constant volume and they hit harder and more often. Heat it at constant pressure and the molecules hit harder, so the gas expands until fewer hits on each square metre per second keep the pressure the same.
Each of the three laws is a special case: cancel whichever quantity stays the same. The constant grows with the amount of gas, which leads to the ideal gas law in 2.8.
Try it first, then reveal one step at a time.
- The volume is constant, so .
- Convert to kelvin: and .
- Rearrange and substitute: . The pressure can stay in kPa because it appears on both sides.
Try it first, then reveal one step at a time.
- The amount of air is fixed, but , and all change, so use .
- Convert to kelvin: and .
- Rearrange and substitute: .
- Check: the pressure falls to under a third and the air warms a little, so the volume should grow a bit over 3.5 times. It does.
A shows each state of a gas as a point. At constant volume a change is a vertical line, and at constant pressure a horizontal one.
At constant temperature it follows a curve on which is constant, called an isotherm. A hotter isotherm lies further from the origin.
Common mistakes
- Using Celsius in the gas laws. Add 273 to every temperature first.
- Explaining gas pressure by molecules colliding with each other. Pressure comes from collisions with the walls of the container.
- Dividing the whole force by the area when it acts at an angle. Use only the component perpendicular to the surface.
- Using = constant when gas leaks in or out, as in a punctured tyre. The law needs a fixed amount of gas.
- Saying a real gas differs from an ideal gas because its molecules move. Name a real difference: its molecules have volume and attract each other, so it can liquefy.
Exam tips
- "Calculate" with the gas laws: write the law, convert temperatures to kelvin, substitute, then give the answer with its unit.
- "Explain, in terms of molecules" a pressure change: one sentence on the speed of the molecules, one on collisions with the walls (harder or more frequent). Each earns a mark.
- "Outline" how a real gas differs from an ideal gas: one property per sentence, such as the volume of the molecules or the forces between them.
- Paper 1A ratio questions: write , cancel what is constant, then apply each factor. Watch for temperatures in degrees Celsius.
Key takeaways
Practise this
92 past-paper questions on Kinetic model and gas laws in the Physics HL bank, each with a mark scheme and a worked explanation.