Dynamic equilibrium and the equilibrium constant
In a minute
A in a closed system settles into : both reactions keep going at the same rate, so nothing seems to change. The expression for the , , comes straight from the balanced equation. Its size tells you how far the reaction goes, and only a change of changes it.
You'll be able to
- Describe what is true of a physical or chemical system at .
- Deduce the expression for from the equation of a homogeneous reaction, using the .
- Use the size of to say how far a reaction has gone at equilibrium, from to .
- Find for the reverse reaction, and explain why only temperature changes the value of .
Before you start2 quick questions on what this builds on
Revise first: 1.1 The particulate nature of matter and 1.8 Concentration and Avogadro's law
Dynamic equilibrium
Seal propanoic acid and ethanol in a flask with a little acid catalyst and keep it warm. Ethyl propanoate and water form. But the reaction never uses up all the acid, however long you wait.
The reason is that the products also react with each other to re-form the reactants. A reaction that can go both ways is a . You write it with the arrow: .
At the start there is no ester, so only the forward reaction happens, and it is fast. As the reactants are used up, the forward rate falls. As products build up, the backward rate rises.
Sooner or later the two rates become equal. From then on, each second, the ester forms exactly as fast as it breaks down. The concentrations stop changing, even though both reactions are still going.
"Dynamic" means the particles are still reacting. Swap a little of the ethanol at equilibrium for ethanol made with a heavy oxygen isotope. The concentrations stay the same, yet the heavy oxygen soon turns up in the ester.
A system at equilibrium has these features:
1. It is closed: no substance enters or leaves. If a product escapes, such as a gas from an open tube, the backward reaction can't keep up and equilibrium is never reached.
2. The forward and backward rates are equal, and both are greater than zero.
3. The concentrations of reactants and products stay constant. They are usually not equal to each other.
4. Macroscopic properties, the ones you can measure, such as colour, pressure and density, stay constant at constant temperature.
5. Equilibrium can be reached from either side. At the same temperature, starting with the reactants or with the equivalent amounts of products gives the same equilibrium mixture.
Physical changes reach equilibrium too. In a sealed bottle half full of water, molecules leave the liquid and others return to it. Once evaporation and condensation happen at the same rate, the water level stops falling.
Try it first, then reveal one step at a time.
- "Describe" asks for a detailed account. Give one feature per sentence, each one a marking point.
- Start with the condition: the flask is sealed, so the system is closed.
- Then the rates, the heart of the definition, and say both reactions continue.
- Then what you can observe: the concentrations, and the measurable properties.
- The system is closed, so no substance enters or leaves. The forward and backward reactions both continue. The rate of the forward reaction equals the rate of the backward reaction. So the concentrations of all four substances remain constant, although they are not equal. Macroscopic properties, such as density, also remain constant.
Try it first, then reveal one step at a time.
- "Explain" needs the reasons, not just the observation. Say what is still happening and why the totals don't change.
- Name the two opposing processes: evaporation and condensation.
- Give the condition that lets vapour build up: the flask is sealed.
- Link equal rates to constant amounts.
- The flask is sealed, so the vapour cannot escape. Molecules still evaporate from the liquid, and vapour molecules still condense back into it. The rate of evaporation equals the rate of condensation. So the amount of liquid and of vapour stays constant: the system is in dynamic equilibrium.
The equilibrium law and K
Run the ester experiment several times at the same temperature, each time from a different starting mixture. The equilibrium concentrations come out different every time.
But one combination of them is always the same, about 4: . Square brackets mean an equilibrium in .
That fixed value is the , . The tells you how to build its expression from the balanced equation.
1. Write the product concentrations on top and the reactant concentrations underneath, each in square brackets.
2. Raise each concentration to the power of its coefficient in the balanced equation. A coefficient of 1 gives power 1, which you don't write.
3. Multiply the terms on each line. Never add them, and never write a coefficient in front of a bracket.
"Homogeneous" means every species is in the same phase, such as all gases or all in one solution. Every species then appears in the expression, except water when it is the solvent. In IB Chemistry, is written without units.
Try it first, then reveal one step at a time.
- The product is , with coefficient 2, so the top is .
- The reactants are , coefficient 2, and , coefficient 1, so the bottom is .
- Check: each species appears once, products are on top, and each power matches its coefficient.
Try it first, then reveal one step at a time.
- All four species are gases, so the reaction is homogeneous and every species goes in, including the water vapour.
- Products on top, with their coefficients as powers: .
- Reactants underneath: .
- The catalyst does not appear: it is not a reactant or product in the equation.
What the size of K tells you
is a ratio of products to reactants at equilibrium. A large means the top of the fraction is large, so the equilibrium mixture is mostly products. A small means it is mostly reactants.
The size of shows the extent of reaction: how far it has gone by the time equilibrium is reached. It says nothing about how fast equilibrium is reached.
(very large, such as ): the reaction goes almost to completion. Hardly any reactant is left.
: products are favoured. The position of equilibrium lies to the right.
: neither side is favoured. Reactants and products are present in comparable amounts.
: reactants are favoured. The position of equilibrium lies to the left.
(very small, such as ): the reaction hardly happens. The mixture is almost all reactants.
The same idea measures acid strength. For an acid ionizing in water, a larger means that, at the same concentration, more of the acid has ionized at equilibrium, so it is a stronger acid. A has a small , usually much less than 1. You'll use this in 6.3.
Now reverse the reaction. Writing backwards swaps the top and bottom of . So the new constant is the reciprocal of the old one.
For a given equation, depends on temperature and on nothing else. Changing a concentration or the pressure moves the mixture, but it settles back to the same . A speeds up both reactions equally, so it doesn't change either.
For an endothermic forward reaction, increases as temperature rises. For an exothermic one, decreases. You'll see why in 5.9.
Try it first, then reveal one step at a time.
- The second equation is the first one reversed, at the same temperature. So .
- Substitute:
- Round to 3 significant figures, the precision of the data: .
- Since , the reverse reaction favours its own product, : the position of equilibrium lies to the right of this equation. That fits the first being less than 1.
Try it first, then reveal one step at a time.
- "Outline" needs a brief account; "deduce" needs a conclusion that follows from the data. Treat each value, then the trend.
- At , , so the equilibrium mixture contains more reactants than products.
- At , , so products are slightly favoured.
- Only temperature changed, and increased as temperature rose. That is the behaviour of an endothermic forward reaction.
- At 700 K, K is less than 1, so reactants are favoured and the position of equilibrium lies to the left. At 1200 K, K is greater than 1, so products are favoured. K increases as the temperature increases, so the forward reaction is endothermic.
Common mistakes
- Saying the concentrations are equal at equilibrium. The rates are equal; the concentrations are only constant.
- Saying the reactions stop at equilibrium. Both continue at the same rate, which is why it is called dynamic.
- Writing coefficients as multipliers, as in . Each coefficient becomes a power: .
- Leaving out the square brackets, or using round ones. Mark schemes require square brackets for every concentration in .
- Thinking a catalyst or a pressure change alters . Only temperature does.
- Taking for the reverse reaction as . It is the reciprocal, .
Exam tips
- "Deduce the equilibrium constant expression": products over reactants, square brackets on every species, coefficients as powers. One mark, and a missing bracket or power loses it.
- "Describe the characteristics" of an equilibrium: give separate points, such as closed system, equal forward and backward rates, constant concentrations and constant macroscopic properties.
- "State the effect on K": only a temperature change has one. For a catalyst, pressure or concentration change, write that stays the same.
- Paper 1A often tests for a reversed equation. Turn the expression upside down and take the reciprocal; don't change the sign.
Key takeaways
Practise this
57 past-paper questions on Equilibrium constants and reaction quotient in the Chemistry HL bank, each with a mark scheme and a worked explanation.
Also: Dynamic equilibrium (5)