1.5.3 · CorePaper 1Paper 2Paper 3Paper 4Paper 5Paper 6

Centre of gravity

In a minute

Every part of an object has weight, but all of it acts as if it pulls down at one point: the . Learn to find it for a flat shape with a plumb line, and why a low centre of gravity and a wide base make an object hard to knock over.

You'll be able to

  • State what the centre of gravity of an object is, and where it is for a simple symmetrical object.
  • Describe how to find the centre of gravity of an irregular flat sheet by hanging it from a pin with a plumb line.
  • Describe how the height of the centre of gravity and the width of the base affect the of an object, and say when it topples.
Before you start3 quick questions on what this builds on
Check yourself
What is the of a about a pivot?
Check yourself
A shelf is in . Which statement must be true?
Check yourself
A box is at rest on the floor. The forces on it are balanced. What happens to the box?

Revise first: 1.5.1 Effects of forces and 1.5.2 Turning effect of forces

What the centre of gravity is

Gravity pulls on every tiny piece of an object. So a ruler has thousands of small downward forces on it, one on each piece.

You don't need to draw thousands of arrows. Together, these small forces act like one , the object's , pulling down at a single point. We call it the .

A uniform object is made of the same material all through. Its centre of gravity lies on every line of symmetry. So when the shape has two or more lines of symmetry, it is at the centre, where they cross: halfway along a uniform ruler, and where the diagonals cross on a uniform rectangular sheet.

The centre of gravity can be outside the material. For a ring, it is at the middle of the hole.

This is why you can balance an object on one support. Put the support directly under the centre of gravity. The weight then acts through the support, so it has no about it and the object doesn't turn.

Worked exampleA uniform metre rule balances on a narrow support at its 50 cm50\ \text{cm} mark. The support is moved to the 35 cm35\ \text{cm} mark. Explain why the rule no longer balances.

Try it first, then reveal one step at a time.

  1. Say where the weight acts. Then compare that point with the support in each position.
Check yourself
Which statement describes the centre of gravity of an object?
Check yourself
Where is the centre of gravity of a uniform rectangular sheet of plywood?

Finding the centre of gravity of a flat shape

A thin flat sheet, such as a piece of card, is called a plane lamina. If its shape is irregular, symmetry can't tell you where the centre of gravity is. So you hang it up and let gravity show you.

An object hanging freely from a pin comes to rest with its centre of gravity directly below the pin. If the centre of gravity were to one side of the pin, its weight would have a about the pin and turn it.

An irregular flat card hangs from a pin held in a clamp stand. The pin passes through a small hole near the top edge of the card. A plumb line, a thread with a small mass on the end, hangs from the same pin and runs straight down across the card. A second small hole is near the right-hand edge of the card. A dashed line, marked earlier when the card hung from that second hole, crosses the card and meets the plumb line at a point labelled G, the centre of gravity, which is directly below the pin. clamp and stand pin card G centre of gravity second hole plumb line (thread and mass) line marked from second hole
Each hanging gives one vertical line through the , G. Two lines cross at G.

You need the card, a clamp and stand, a pin, a pencil and a plumb line: a small mass hanging on a thread, which shows the vertical.

1. Make three small holes near the edge of the card, well apart.

2. Push the pin through one hole and clamp it, so that the card hangs and can swing freely.

3. Hang the plumb line from the pin. Wait until the card and the thread are both still.

4. Mark two points on the card under the thread, one high and one low, then join them with a ruler.

5. Hang the card from a second hole and repeat. The centre of gravity is where the two lines cross.

6. Repeat from the third hole as a check. Its line should pass through the same point.

Worked exampleA student cuts the outline of an island from thick card. She has a clamp and stand, a pin, a thread with a small mass on the end, and a pencil. Describe how she can find the centre of gravity of the card.

Try it first, then reveal one step at a time.

  1. Give the steps in order: hang the card, find the vertical, mark it, repeat, then say where the centre of gravity is.
Check yourself
A flat card hangs freely from a pin and has stopped swinging. Where is its centre of gravity?
Check yourself
After marking lines from two holes, a student hangs the card from a third hole. Why?

Centre of gravity and stability

Tilt a tall box a little and let go: it falls back onto its base. Tilt it too far and it falls over. Where its weight acts decides which happens.

While the box is tilted, it turns about the edge of its base, so that edge is the pivot. The weight acts vertically down from the .

1. If the vertical line down from the centre of gravity passes inside the base, the weight's turns the box back onto its base.

2. If that line passes outside the base, the weight's moment turns the box further over, and it topples.

Two drawings of the same tall block tilted onto its right-hand bottom edge, which acts as the pivot. In the left drawing the block is tilted a little. A weight arrow points straight down from its centre of gravity, G, and a dashed vertical line from G reaches the ground inside the base, to the left of the pivot. The label says the weight turns the block back onto its base. In the right drawing the block is tilted further. The dashed vertical line from G now reaches the ground outside the base, to the right of the pivot. The label says the weight turns the block over and it topples. G weight pivot line of weight inside base: falls back G weight pivot line of weight outside base: topples
The same block: it falls back while the line of its weight is inside the base, and topples once it is outside.

Two things make an object more : a lower centre of gravity, and a wider base in contact with the ground. Both mean it must tilt further before the line of its weight moves outside the base.

Mass alone doesn't decide this. A heavier object needs a bigger push to tilt, but with the same shape and the same height of centre of gravity, it topples at the same angle.

Worked exampleA desk lamp has a heavy metal base and a light plastic arm. Explain why the heavy base makes the lamp less likely to fall over when it is knocked.

Try it first, then reveal one step at a time.

  1. Say where the heavy base puts the centre of gravity, then what happens to the line of the weight when the lamp tilts.
Worked exampleA camera sits on a tripod with three legs of fixed length. Explain why spreading the legs further apart makes the camera less likely to be knocked over.

Try it first, then reveal one step at a time.

  1. Spreading the legs changes two things: the width of the base and the height of the camera. Deal with each.
Check yourself
A tall, straight-sided plastic bottle stands upright on a table. When is it most stable?
Check yourself
A tall block is tilted onto one edge and released. When does it fall back onto its base?

Common mistakes

  • Saying a heavier object is always more stable. Stability depends on how low the centre of gravity is and how wide the base is, not on mass alone.
  • Writing that one object is "wider" or has a "bigger surface area". Say which part: the base in contact with the ground is wider.
  • Thinking a shape that is narrow in the middle, like an hourglass, must be unstable. What matters is how wide the base is and where the centre of gravity is (how low, and whether it is over the base), not the width higher up.
  • Marking the line on the card while it is still swinging. Wait until the card and the plumb line are still, or the line will miss the centre of gravity.

Exam tips

  • "State" the meaning of centre of gravity in one sentence, using the word weight: the point through which all the weight of the object can be taken to act.
  • "Explain" why one object is more stable than another: give a reason for each mark, such as a lower centre of gravity or a wider base, so it must tilt further before the line of its weight leaves the base.
  • "Describe" the plumb-line experiment in order: hang the card freely, hang the plumb line from the same pin, mark the vertical line, repeat from another hole, then say the centre of gravity is where the lines meet.

Key takeaways

Learn thisThe centre of gravity is the point through which all the weight of an object can be taken to act. For a uniform object it lies on every line of symmetry, so for a uniform ruler, rectangular sheet or ring it is at the centre.
Learn thisTo find the centre of gravity of a flat irregular sheet: hang it freely from a pin and mark the vertical line of a plumb line from the pin. Repeat from a second hole. The centre of gravity is where the two lines meet.
Learn thisA tilted object, when released, falls back onto its base if the vertical line down from its centre of gravity passes inside the base. It topples if the line passes outside the base.
Learn thisAn object is more stable when its centre of gravity is lower or its base is wider: it must tilt further before it topples.

Practise this

No Extended questions on Centre of gravity yet; 13 in the 0625 Core papers.

Practise Centre of gravity →