Electric and magnetic field lines
In a minute
Every sets up an , a region where other charges feel an . The is the force per coulomb. Field lines show its direction, and their spacing shows its strength. Magnets and currents set up , drawn the same way.
You'll be able to
- Use to find a field strength, or the force on a charge and its direction.
- Sketch and interpret for point charges, a charged conducting sphere and two charges.
- Compare field strengths from line spacing, and use for a point charge.
- Use for the between parallel plates, and describe the edge effects.
- Sketch and interpret for a bar magnet, a wire, a coil and a solenoid, and find the field direction round a wire.
Before you start3 quick questions on what this builds on
Revise first: 1.5 Contact and field forces, 2.12 Current, potential difference and emf, 4.4 Electric charge and Coulomb's law and 6.2 Scalars and vectors
Electric field strength
Two charges push or pull each other without touching. We describe this with a field: a charge changes the space around it, and any other charge placed in that space feels a force.
To measure the field at a point, imagine a small positive there and find the force on it. It is small so that it doesn't disturb the charges making the field.
is measured in newtons per coulomb, . It is a : its direction is the direction of the force on a positive charge.
is in section D.2 of the data booklet. So is every constant in this lesson that a question doesn't give, such as and .
Rearranged, . A positive charge is pushed along the field. A negative charge, such as an electron, is pushed the opposite way.
Try it first, then reveal one step at a time.
- Use with the charge in coulombs: .
- .
- The grain is positive, so the field points the same way as the force: due east.
Try it first, then reveal one step at a time.
- Upwards is positive, so the field is .
- The electron's charge is , from the data booklet.
- .
- The positive sign means the force is upwards, opposite to the field, as it must be for a negative charge.
Field lines and field strength
A field line is a way of drawing a field. Put a small positive charge anywhere on a line, and the force on it acts along the line, in the direction of the arrow.
Four rules for drawing them:
1. Lines start on positive charges and end on negative charges, or run to or from infinity.
2. Lines never cross. A crossing would give the field two directions at one point.
3. Lines meet the surface of a conductor at right angles, once its charges have stopped moving.
4. The number of lines drawn from a charge is proportional to its size.
Around a point charge the field is radial: straight lines out from a positive charge, or in towards a negative one. The lines spread apart further out, so the field weakens.
Combine , , with . The test charge cancels, which leaves the field a distance from a point charge :
This is an inverse square law: at three times the distance, the field is as strong.
An isolated charged conducting sphere holds its charge on its surface. Outside, its field is the same as a point charge at its centre, so measure from the centre.
Inside a conductor, once the charges stop moving, . Any field would push the free electrons until it vanished. So no lines are drawn inside.
Try it first, then reveal one step at a time.
- One marking point per sentence: radial lines, spreading apart, density shows strength, so weaker.
- The field lines around a point charge are radial. As the distance from the charge increases, the lines spread further apart. The density of the field lines represents the field strength. So the field strength decreases with distance from the charge.
Try it first, then reveal one step at a time.
- Outside the sphere, treat its charge as a point charge at the centre, so , not the distance from the surface.
- .
- , directed radially away from the sphere because its charge is positive.
Fields of two charges
When two charges are near each other, the field at any point is the vector sum of their separate fields.
Between unlike charges, both fields point from the positive charge towards the negative one. They add, so the lines crowd together there.
Between like charges, the fields point in opposite directions and cancel at one point. This neutral point has , and no line passes through it.
A larger charge gets more lines and a stronger field, so the neutral point is closer to the smaller charge.
Try it first, then reveal one step at a time.
- Between like charges the fields are opposite, so where they are equal in size.
- , so and cancel.
- Take square roots: .
- , so and m.
- Sense check: the neutral point is nearer the smaller charge, as it should be.
Try it first, then reveal one step at a time.
- Give each field's direction between the charges, then combine them.
- Between the charges, the field of the positive charge points away from it, towards the negative charge. The field of the negative charge points towards the negative charge, so it is in the same direction. The two fields therefore add instead of cancelling. So the resultant field between the charges is never zero.
The uniform field between parallel plates
Connect two flat metal plates to a power supply and they become charged, one positive and one negative. Between them the field lines are straight, parallel and equally spaced, pointing from the positive plate to the negative plate.
For plates a distance apart, with a between them, the field strength is:
So can also be given in volts per metre, and .
Near the ends of the plates the lines bow outwards. These edge effects mean only holds well inside the plates, away from the edges.
Try it first, then reveal one step at a time.
- Convert to SI units: and .
- .
- This is the field anywhere between the plates, away from the edges. It points from the positive plate to the negative plate.
Try it first, then reveal one step at a time.
- The drop is stationary, so the upward electric force balances its weight: .
- .
- . Keep the unrounded in your calculator.
- The force is up, towards the positive plate, so the drop is negative. Its charge is : three extra electrons.
Magnetic field lines
Magnets and currents have a different kind of field around them, which turns a compass needle.
Like electric field lines, they never cross, and closer lines mean a stronger field. Outside a magnet they run from its north pole to its south pole.
Unlike electric field lines, they have no ends. They carry on through the magnet from south to north, forming closed loops.
Round a long straight wire carrying a current, the lines are circles centred on the wire. They spread out further away, where the field is weaker.
To find their direction, use the right-hand grip rule. Point the thumb of your right hand along the conventional current, and your fingers curl the way the field lines go.
In diagrams, means current coming out of the page towards you, and means current going into the page. For current out of the page, the lines go anticlockwise.
In a flat circular coil, the lines circle the wire close to it. Through the middle they all point the same way, so the field there is strong.
A solenoid is a long coil. Inside, away from the ends, the lines are straight, parallel and equally spaced, so the field is uniform. Outside, it looks like a bar magnet's field, with lines leaving the north end.
To find the north end, curl the fingers of your right hand the way the current flows round the turns. Your thumb then points to the north end.
Try it first, then reveal one step at a time.
- Thumb along the current, then look down from above: the current comes towards you.
- Find which way an anticlockwise circle heads at its east side.
- Using the right-hand grip rule, the thumb points upwards along the current. Seen from above, the fingers curl anticlockwise round the wire. At a point due east of the wire, an anticlockwise circle is heading north. So the magnetic field at the compass points north.
Try it first, then reveal one step at a time.
- Inside: shape and spacing of the lines. Outside: compare with a familiar pattern.
- Inside the solenoid, the field lines are straight, parallel and equally spaced, so the field is uniform along most of its length. The field inside is strong because the fields of all the turns add together. Outside, the field is much weaker, and the lines spread out like the field of a bar magnet. The lines form closed loops, leaving the north end and entering the south end.
Common mistakes
- Ignoring direction. is a vector, and a negative charge is pushed against it.
- Using instead of for a point charge. Tripling the distance cuts to , not .
- Measuring from the surface of a charged sphere. Use the distance from its centre.
- Drawing field lines that cross, stop in mid-air, or have no arrows.
- Using with in millimetres, or near the edges of the plates where the field is not uniform.
- Getting the grip rule backwards. Use your right hand, with the thumb along the conventional current.
Exam tips
- Asked what electric field strength is? Give both marking points: force per unit charge, on a small positive test charge.
- "Sketch" field lines: arrows on every line, more lines on the larger charge, right angles at conductors, and spacing that shows strength. For plates, show the edge effects.
- In a Paper 1A question, reason with ratios: double and halves; triple and a point charge's falls to .
- "Determine the direction" round a wire: name the right-hand grip rule, then give the direction in the question's terms.
Key takeaways
Practise this
98 past-paper questions on Electric charge, fields, potential and energy in the Physics HL bank, each with a mark scheme and a worked explanation.