Gravitational potential and potential energy
In a minute
Far from a planet, no longer fits, because changes with distance. Instead you measure from infinity, where it is zero, so it is always negative. is the same idea per kilogram. Its slope gives the field, and surfaces of equal potential show where moving costs no .
You'll be able to
- Explain why gravitational potential energy is the work done to assemble a system from infinity, and calculate it with .
- Define and calculate it with , including at a point between two bodies.
- Find the field strength as minus the , from data or from a graph of against .
- Calculate the work done moving a mass between two points with .
- Sketch and explain why they cross field lines at right angles.
Before you start3 quick questions on what this builds on
Revise first: 1.1 Describing motion, 1.9 Work and energy transfer, 1.10 Mechanical energy and 4.1 Gravitation: Kepler's laws and Newton's law
Gravitational potential energy of a system
Near Earth's surface you used . That works only while stays constant. A satellite thousands of kilometres up feels a much weaker pull, so you need a version that works at any distance.
The trick is to pick a zero that every system shares: infinite separation. Two bodies infinitely far apart do not pull on each other at all, so their is defined as zero there.
Gravity is attractive. As you bring a mass in from infinity, gravity pulls it in, and you must hold it back to stop it speeding up. Your force points outwards while the mass moves inwards, so the you do is negative.
So the potential energy at any finite separation is less than zero. Pulling the bodies apart again takes positive work, and rises towards zero.
and are the two masses and is the distance between their centres of mass. As in , a uniform sphere acts as a at its , as long as you are at or outside its surface.
comes from the data booklet. All four equations in this lesson are in the higher level part of booklet section D.1, so you don't need to memorise them; you need to know when to use them.
Try it first, then reveal one step at a time.
- Write the equation: .
- Substitute, with from the planet's centre: .
- , then round to 2 significant figures, as the data are given to 2.
- Sense check: the answer is negative, as every gravitational must be.
Try it first, then reveal one step at a time.
- Start from the definition: work done to assemble the system.
- Say where the zero is.
- Use the direction of the force to find the sign of the work.
- Then deal with moving outwards.
- Gravitational potential energy is the work needed to bring the bodies together from infinitely far apart. It is defined as zero at infinity. Gravity is attractive, so the probe is pulled inwards as it is brought in. The agent bringing it in must push outwards against the motion, so the work done is negative. So the potential energy at any finite separation is less than zero. Moving the probe outwards needs positive work against the attraction, so the potential energy becomes less negative, rising towards zero.
Gravitational potential
Potential energy depends on both masses. Often you care about a point in space, whatever is placed there. So divide by the mass you bring in: energy per kilogram.
is the mass creating the field and the distance from its centre. Like potential energy, is zero at infinity and negative everywhere else. Outside the body, it is most negative at the surface, where is smallest.
Multiply by the mass placed at the point and you get the potential energy: . Check: .
Potential is a scalar: it has no direction. At a point near two bodies, add the potential from each, minus signs included. This is easier than adding field strengths, which are vectors.
Try it first, then reveal one step at a time.
- At the surface, is the radius: .
- , so to 2 significant figures.
- Going further: a height equal to the radius puts the point at from the centre. , so the potential halves: about .
Try it first, then reveal one step at a time.
- P is from the moon's centre.
- Planet: .
- Moon: .
- Potential is a scalar, so add: .
- The two fields point in opposite directions at P and partly cancel, but the potentials never cancel. Both are negative.
Field strength as a potential gradient
Think of potential as height on a hill. A ball on a hill is pushed downhill, and the push (and so its acceleration) is greatest where the slope is steepest. In the same way, a mass is pushed towards lower potential, and the push is strongest where the potential changes fastest.
So the is minus the . With measured outwards, rises as grows, so comes out negative: the field points inwards, towards lower potential. Most questions ask only for its size.
On a graph of against , the of the tangent at a point gives the field strength there. Near the planet the curve is steep, so the field is strong. Far away the curve flattens, so the field is weak.
Try it first, then reveal one step at a time.
- Change in potential, final minus initial: .
- Change in distance: .
- .
- The minus sign means the field points inwards. Its magnitude is . This is an average over the gap, so it is an estimate.
Try it first, then reveal one step at a time.
- Write both booklet equations for the surface, : and .
- Divide the first by : .
- Substitute: , so to 2 significant figures.
- You never needed or : the potential already contains them.
Work done moving a mass
Potential is energy per kilogram. So to move a mass between two points, multiply its mass by the change in potential.
. is the done on the mass by an outside agent, such as a rocket, moving it without changing its speed. It equals the change in of the system.
Moving away from a planet, rises, so is positive: you must supply energy. Moving towards it, is negative: the field does the work instead. With no other forces, a falling mass gains kinetic energy equal to times the drop in potential.
Near the surface, the field is almost uniform, so and , the equation from 1.10. It is a special case, valid only when is tiny compared with the planet's radius.
Try it first, then reveal one step at a time.
- Potential at the surface: .
- Potential at the new point: .
- . Keep the unrounded values.
- .
- Using with surface would give three times this, because weakens as the satellite rises. To put the satellite into orbit, it also needs kinetic energy: see 4.3.
Try it first, then reveal one step at a time.
- The field does the work, so the kinetic energy gained equals the potential energy lost: .
- The mass cancels: .
- Drop in potential: .
- , so to 2 significant figures.
Equipotential surfaces
Join up all the points that have the same potential and you get a surface, like a contour line on a map joining points at the same height.
On an , , so . No work is done moving a mass along it. The field is still there; it just has no component along the surface.
That is why field lines always cross equipotentials at right angles. Around a planet, the field lines are radial and the equipotentials are concentric spheres. Close to the surface, the field is almost uniform: parallel field lines and flat, horizontal equipotentials.
Draw equipotentials at equal steps in potential and their spacing shows the field strength. In a radial field they spread out with distance, because gets weaker. In a uniform field they are equally spaced.
To map a field from potential: draw the equipotentials, then draw field lines at right angles to them, pointing towards lower potential.
Try it first, then reveal one step at a time.
- Say what is constant on an equipotential.
- Use to find the work done moving along it.
- Argue what a component of the field along the surface would do.
- On an equipotential surface the potential is the same everywhere, so the change in potential along it is zero. By , no work is done moving a mass along the surface. If the field had a component along the surface, the gravitational force would do work on a mass moved along it. So the field has no component along the surface. The field lines must therefore be perpendicular to the equipotential surfaces.
Try it first, then reveal one step at a time.
- Rearrange : each surface is a sphere of radius , with .
- Radii: , , .
- First gap: , so to 2 significant figures.
- Second gap: , twice as big. The steps in potential are equal, but the field is weaker further out, so you must travel further for the same change.
Common mistakes
- Using the height above the surface as . In and , is measured from the centre: add the planet's radius.
- Dropping the minus sign. Potential and potential energy are zero at infinity and negative everywhere else; a positive answer is wrong.
- Treating potential as a vector. It is a scalar: add the values from each body, signs included, with no directions.
- Using for a change in height comparable to the planet's radius. Use with at each point.
- Getting backwards. It is final minus initial, so moving away from a planet gives positive work done by whatever moves the mass.
Exam tips
- "Define" gravitational potential: the work needed per kilogram to move a small mass to the point from infinity. Leaving out "per unit mass" or "from infinity" loses the mark.
- "Show that" questions linking and : write both booklet equations, then divide or substitute to reach the given result.
- In Paper 1A, potential questions often compare points. Potential varies as and field strength as : check which one is asked for.
- "Sketch" equipotentials: draw them at right angles to every field line, closer together where the field is stronger.
Key takeaways
Practise this
124 past-paper questions on Circular motion and gravitation in the Physics HL bank, each with a mark scheme and a worked explanation.