Physical quantities and measurement techniques
In a minute
Every experiment starts with a good measurement. Use a ruler for lengths, a measuring cylinder for volumes, and a clock, stopwatch or digital timer for times. To measure something very small or very quick, measure many of them together and divide. Extended adds and , and how to combine two vectors that act at right angles.
You'll be able to
- Measure a length with a ruler and a volume with a measuring cylinder, including the volume of an irregular solid.
- Choose a clock, stopwatch or digital timer to suit a time interval, and read it correctly.
- Find an average for a small distance or a short time by measuring many together, including the of a pendulum.
- Tell scalars from vectors, and name the examples of each that you need to know.
- Find the resultant of two forces or two velocities at right angles, by calculation or with a scale drawing.
Before you start3 quick questions on what this builds on
Measuring length and volume
A ruler or metre rule measures length. Most read to the nearest millimetre (). Line the zero mark up with one end of the object. If the end of the ruler is worn, start at another mark and subtract that starting reading.
Look straight at the mark you are reading, not from the side. Looking at an angle makes the reading too big or too small: a parallax error.
For a regular solid, such as a cuboid, measure its length, width and height with a ruler. Then volume = length × width × height.
A measuring cylinder measures the volume of a liquid, in ( = ml). Stand it on a flat bench. The water surface curves at the glass: this curve is the meniscus. Read the scale at the bottom of the meniscus, with your eye level with it.
Try it first, then reveal one step at a time.
- Find what one small division is worth. The numbered marks and are apart, with spaces between them: per division.
- The bottom of the meniscus is small divisions above the mark.
- Volume .
You can't work out the volume of an irregular solid, such as a stone, from a formula. Use the instead. Read the water level, lower the solid in until it is fully under water, and read the level again. The rise in level is the solid's volume.
Try it first, then reveal one step at a time.
- The key pushes aside its own volume of water, so the level rises by the key's volume.
- Volume of key = new reading − starting reading.
- .
Measuring time
Choose the timer to suit the interval. A clock or watch is fine for minutes or hours, such as a hot drink cooling. A stopwatch suits intervals of several seconds, such as a trolley rolling down a ramp. A digital timer, started and stopped by light gates, suits very short intervals, well under a second.
A stopwatch shows , but you start and stop it by hand. Your reaction time is roughly , so the last digit of a hand-timed reading can't be trusted. A light gate has no reaction time.
Reset the stopwatch to zero before you start. If you forget, the time interval = final reading − starting reading. A display of 1:05.32 means minute seconds, which is .
Try it first, then reveal one step at a time.
- Change the final reading to seconds: .
- The starting reading is .
- Time interval = final reading − starting reading: .
Try it first, then reveal one step at a time.
- Estimate each interval first: hours, a few seconds, a small fraction of a second.
- Match the timer to the size of the interval.
- For (c), compare the interval with your reaction time.
- (a) A clock, because the candle takes hours to burn. (b) A stopwatch, because the roll lasts a few seconds. (c) A digital timer with light gates. The ball passes through the gap in a small fraction of a second, which is shorter than human reaction time, so it can't be timed by hand.
Measure many, then divide
A sheet of paper is about thick: too thin for a ruler marked in millimetres. A stack of sheets is about thick, which a ruler can measure. Measure the stack, then divide by the number of sheets to get the average thickness of one.
Short times work the same way. One complete oscillation (out and back) of a classroom pendulum takes about to s, not much longer than your reaction time. Time oscillations and the reaction-time error is shared between all .
Put a fixed marker below the centre of the swing. The bob moves fastest there, so the moment it passes is sharp and easy to see. Count "zero" as you start the stopwatch, and stop it after complete oscillations.
Try it first, then reveal one step at a time.
- Find the mean time for oscillations: .
- Divide by the number of oscillations: .
- , which is to 3 significant figures, like the readings.
Try it first, then reveal one step at a time.
- Say where the marker goes and why.
- Say what is timed: many complete oscillations, not one.
- Say how the period is worked out, and how to make it more reliable.
- Place a fixed marker below the centre of the swing, where the bob moves fastest. Start the stopwatch as the bob passes the marker. Time complete oscillations, counting each time the bob passes the marker going the same way. Divide the total time by to get the period. Repeat the timing and calculate the mean.
Scalars, vectors and resultants Extended only
Scalars to know: , , time, , and . Vectors to know: , , and , , and the two field strengths ( and electric).
Watch the pairs. Speed is a scalar, but velocity is speed in a given direction, so it is a vector. Mass is a scalar, but weight is a force, so it is a vector.
The resultant of two vectors is the single vector with the same effect as both. When two forces or two velocities act at right angles, draw them tip to tail. They make the two short sides of a right-angled triangle, and the resultant is the longest side.
and are the two vectors at right angles. Pythagoras gives the size of the resultant. is the angle between the resultant and , so it gives the direction.
Try it first, then reveal one step at a time.
- The forces are at right angles, so use Pythagoras: .
- , which is to 2 significant figures.
- Direction: , so (to 2 significant figures) north of east.
Try it first, then reveal one step at a time.
- Choose a scale: = . The boat's velocity is long and the river's is long.
- Draw north. From its tip, draw east, at right angles.
- Join the start to the end. It measures : .
- Measure with a protractor: about east of north.
- Check by calculation: .
Common mistakes
- Using a ruler for the volume of an irregular object. Use displacement in a measuring cylinder.
- Timing a single swing of a pendulum. Time at least complete oscillations and divide, so reaction time matters less.
- Forgetting the starting reading on a stopwatch or ruler. Subtract it from the final reading.
- Reading a stopwatch display such as 1:05.32 as . It is minute seconds, .
- Counting from one side of the swing to the other as a whole oscillation. That is half of one.
- Extended: adding two vectors at right angles. Use Pythagoras or a scale drawing.
Exam tips
- "Describe" a measurement (Paper 3/4 and 5/6): name the instrument, say what you read and how (eye level, starting reading), and how you get the final value (subtract, or divide by the number).
- "Calculate" a period or an average: show the total, the number you divide by, and the answer with its unit.
- "Determine" a resultant (Extended): give its size with a unit and its direction, such as " at north of east".
Key takeaways
Practise this
30 past-paper questions on Physical quantities and measurement techniques in the 0625 Extended bank, each with a mark scheme and a worked explanation.