Normal distribution
In a minute
The models measurements such as heights and masses, which cluster symmetrically around a mean. Its probabilities are areas under a bell-shaped curve. You estimate them with the 68–95–99.7 rule on Paper 1, and find them exactly with your GDC on Paper 2, forwards or backwards.
You'll be able to
- Describe the normal curve, its properties and where it occurs, and read the notation .
- Use symmetry and a sketch to find normal probabilities without a calculator.
- Use the 68–95–99.7 rule to estimate probabilities and expected numbers.
- Find normal probabilities with your GDC, including given-that probabilities.
- Find the value with a given probability below or above it, or the bounds of a middle region, using inverse normal.
Before you start3 quick questions on what this builds on
Revise first: 4.3 Central tendency and dispersion, 4.6 Probability diagrams, rules and independence and 4.7 Discrete random variables and expected value
The normal curve
Weigh a thousand apples from one orchard. Most masses sit close to the average, and extreme ones are rare on both sides. A histogram with narrow bars then has a smooth bell-shaped outline: the normal curve. Heights, lengths, times and measurement errors often behave this way.
A height is a : it can take any value in a range, not just separate values as in 4.7. So its probabilities are areas under a curve, not sums of single probabilities.
In , is the . The second number is the , not the . So has . Questions often write to make easy to see.
1. The curve is bell-shaped and symmetric about the vertical line through . So the mean, and mode are all equal to .
2. The total area under the curve is , because is certain to take some value.
3. The curve gets closer and closer to the horizontal axis on both sides but never touches it. Values far from are possible, just very unlikely.
4. fixes where the centre is. fixes the spread: a larger gives a wider, flatter curve, since the area must still be .
Symmetry gives you some probabilities with no calculator. Half the area lies on each side of the mean. Two tails that start the same distance from have equal areas.
Try it first, then reveal one step at a time.
- Read the model: the mean is and the standard deviation is .
- The curve is symmetric about , so half of the area lies to the right of .
- Including itself makes no difference, because .
Try it first, then reveal one step at a time.
- The two tails have equal areas, so and are the same distance from the mean. The mean is halfway between them: .
- The area between and is .
- By symmetry, half of that area lies between and the mean : .
- Check: , which is the whole area to the left of the mean.
The 68–95–99.7 rule
Every normal curve has the same shape: slides it along and stretches it. So the same fraction of values lies less than one from , for every normal distribution, whatever the values of and .
This is the . It is not in the formula booklet, so learn it.
Use symmetry to split the bands. Half of lies on each side of the , so lies between and . Half of is , so lies between and .
The outside is shared by the two tails: in each. Likewise lies above .
Try it first, then reveal one step at a time.
- Write each bound as a number of from the mean: and .
- So the interval is , which holds about of the values.
Try it first, then reveal one step at a time.
- Convert the bounds: and . The interval is not symmetric, so split it at the mean.
- From to : half of , which is .
- From to : half of , which is .
- Add the pieces: .
- The expected number is , as in 4.5: .
Try it below. The shading starts at and shows . Drag the bounds to and to see . The rule rounds these exact areas.
Probability =
z-scores: a → b →
The z-scores it lists count standard deviations from the mean. They belong to 4.12.
Normal probabilities on your GDC
The rule only works at whole numbers of . For other bounds, your GDC's normal cdf finds the area between two bounds.
1. Sketch the curve, mark and the bounds, and shade the area you want.
2. Write the probability statement and the parameters, such as with , .
3. Enter the lower bound, upper bound, and . Enter , not .
4. For less than , use a huge negative lower bound, . For more than , use as the upper bound.
Try it first, then reveal one step at a time.
- Sketch: in the centre, to its left and to its right. Shade between them.
- Write down the calculation: with , .
- Normal cdf with lower bound and upper bound gives
- Sense check: runs from to , which holds about . The interval here is a little wider, so a value just above makes sense.
For a given-that question, use from 4.6. Here is where the two intervals overlap: sketch them.
Try it first, then reveal one step at a time.
- Write the condition down: .
- Find the overlap. Every parcel under kg is also under kg, so the numerator is . Normal cdf with lower bound and upper bound gives
- Find the denominator:
- Divide the stored values:
Inverse normal: from a probability to a value
Sometimes you know the area and need the boundary: the mark the lowest fall below, or the mass only of boxes exceed. This is an calculation.
Inverse normal works with the area to the left of . So turn every condition into a left-hand area first.
1. : enter the area .
2. : the area to the left of is , so enter .
3. A middle region of probability , centred on : the tails share , so each holds . The lower bound has area to its left, and the upper bound has .
In this lesson and are always given. When one of them is unknown, you work with the standardised value instead, in 4.12.
Try it first, then reveal one step at a time.
- Sketch: a small shaded tail on the left, so must be below .
- Write the condition: . It is already a left-hand area.
- Inverse normal with area , , gives
- Check: , as the sketch said.
Try it first, then reveal one step at a time.
- Write the condition: .
- Turn it into a left-hand area: .
- Inverse normal with area , , gives
- Check: the heaviest boxes are above the , and . The mass is g.
Try it first, then reveal one step at a time.
- Outside the middle lies , shared equally: in each tail.
- Lower bound: , so inverse normal gives
- Upper bound: the area to the left of is , so
- Check the symmetry: and .
Common mistakes
- Typing the variance into the GDC's standard deviation field. In the second number is , so take its square root first.
- Using the area in inverse normal when . Inverse normal wants the area to the left, so enter . A sketch shows must be above the mean.
- Putting all the leftover area in one tail for a middle region. For the middle , each tail holds , so the bounds have areas and to their left.
- In a given-that question, stopping at . Divide by the probability of the condition, .
- Using normal pdf to find a probability. For a continuous variable ; normal pdf gives the height of the curve, not an area.
- Rounding a probability to 3 s.f. and then using it in a later step. Store the full value, and round only the final answer.
Exam tips
- Sketch: draw a symmetric bell, mark the mean, label the bounds and shade the region. It shows at once whether the answer should be above or below 0.5.
- On Paper 2, write down the probability statement and the parameters, such as with , , before the answer. That line earns the method mark.
- Paper 1 has no calculator, so normal questions there use symmetry and the 68–95–99.7 rule. Write down needs no working, but check which side of the mean each bound is on.
- Give probabilities to 3 s.f. unless told otherwise. If a later part uses an earlier probability, use the stored value; a wrong earlier answer used correctly can still earn follow-through marks.
Key takeaways
Practise this
15 past-paper questions on 4.9 in the AA HL bank, each with a mark scheme and a worked explanation.